Bedienungsanleitung Pulsar 8F56 (Seite 10 von 14) (Englisch)

593556

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

English

1918

NOTES ON OPERATING THE WATCH

TIME (DUAL TIME) / DATE SETTING

● When setting the date, turn the crown counterclockwise to advance the date and

clockwise to move it back. The date changes one day by turning the hour hand two

full circles.

● The date changes between 11:45 p.m. and 0:30 a.m. while the watch is in operation

and between 9:00 p.m. and 3:00 a.m. when it is changed manually by turning the

hands. Therefore, note the following.

[AM/PM checking]

When setting the hour hand, check that AM/PM is correctly set.

* When setting the time by advancing the hands, turn the hour hand past the 3

o’clock marker. If the date advances, the time is set for the AM period. If it does

not change, the time is set for the PM period.

* When setting the time by turning back the hands, turn the hour hand past the 9

o’clock marker. If the date moves back, the time is set for the PM period. If it does

not change, the time is set for the AM period.

[Setting the time between 9:00 p.m. and 3:00 a.m.]

* If the time is adjusted to the time period between 9:00 p.m. and 3:00 a.m., the

date may not change properly. The watch, however, will indicate the date

properly after 3:00 a.m.

* To prevent this from occurring, first turn back the hour hand past 9:00 p.m.,

checking that the date moves back to the previous day, and then, advance the

hands to the desired time.

TIME DIFFERENCE ADJUSTMENT DURING TRIP

● To put back the time, turn the crown clockwise. To advance the time, turn it

counterclockwise.

● When moving back the hour hand past the 12 o’clock marker to set it to a time

between 9:00 p.m. and 0:00 a.m., put back the hour hand further past 8:00 p.m., and

then advance it to the desired hour.

TIME DIFFERENCE

● The time differences and the use of daylight saving time (summer time) may change

in some areas or countries when they are so decided by the countries concerned.

HOW TO CHECK THE CALENDAR

● If the crown is pulled out to the second click instead of the first click and pushed back

in to the normal position, the watch will not show the calendar.

● Do not leave the crown at the first or second click when you use the watch, as this

will shorten the battery life.

● Note on the leap second

One day normally is said to consist of 86,400 seconds. In fact, it can be longer

or shorter than this because of irregular changes in the rotation cycle of the

earth. When the accumulated fluctuations in the length of a day total plus or

minus one second, one second must then be added or subtracted as a

correction factor. This is known as a “leap second”.

● When setting the minute hand, advance it 4 to 5 minutes ahead of the desired time

and then turn it back to the exact time.

● The hour hand moves in one hour increments.

● When adusting the date and hour hand, turn the crown slowly. In doing so, the other

hands may move slightly. However, this is not a malfunction.

05.4.19, 9:10 AMPage 18-19

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pulsar 8F56 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info