8
Switching between Sleep, Standby and On
Contour has three power modes, Standby, Sleep and On. In Standby, Contour
uses minimal power (Status LED is bright red). In Sleep mode, Contour remains
connected to the wireless network and waits for a source to be selected (Status
LED is dimmed red).
To enter Sleep mode, press Standby. Contour will automatically enter Sleep mode
after 15 minutes if it does not receive any audio from AirPlay or a docked iPod/
iPhone/iPad.
Once in Sleep mode, press Standby to switch to On.
To enter Standby, press and hold Standby for four seconds on Contour, or the
remote until the Status LED is bright red. Press Standby to switch straight to On.
Contour will flash red for around 30 seconds, pause, and then return to the state
that Contour was in before Standby.
Network setup
Contour can be connected to your network using a wireless or wired connection.
We recommend using the wireless connection method, which allows you to
position your Contour anywhere within range of your wireless network. Contour
can be connected to your wireless network using Wi-Fi Network Login Sharing or
manually. See page 9 for more information.
To use the wired connection method, connect an Ethernet cable between the
Ethernet port on the back of Contour and one of the available Ethernet ports on
your router. You might want to use this method if you experience sound quality
problems or if your Contour is located near your router. See page 13 for more
information.
