Bedienungsanleitung Quadra-Fire Castile - Pellet - Insert (Seite 21 von 40) (Englisch)

815528

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

21 02/237022-802K

12. Door Latch Inspection

• Frequency: Prior to heating season

• By: Homeowner

The door latch is non-adjustable but the gasket between the

glass and rebox should be inspected periodically to make

sure there is a good seal.

13. Cleaning Exhaust Blower - Requires No Lubrication

• Frequency: Yearly or as needed

• By: Quality Service Technician/Homeowner

Remove left & right brick. The exhaust blower is behind

the right brick (Figure 20.2 on page 20). Vacuum this area

thoroughly. See Brick replacement on page 26 for removing

bricks. Re-install bricks when done.

14. Cleaning Convection Blower - Requires No

Lubrication

• Frequency: Yearly or as needed

• By: Qualied Service Technician

• Task: Contact your local dealer.

15. Preparing Firebox for Non-Burn Season

• Frequency: At the end of the heating season

• By: Homeowner

a. Be sure the appliance is allowed to cool, has been

unplugged and the exhaust blower is off.

b. Remove all ash from the rebox and

vacuum thoroughly.

c. Paint all exposed steel, including cast-iron.

— Use the Touch-Up paint supplied with the

appliance; or,

— Purchase paint from your local dealer.

— Must use a high-temperature paint made

specically for heating appliances.

10. Soot and Fly Ash: Formation & Need for Removal

in Exhaust Venting System.

• Frequency: Yearly or more frequently depending on

ash build-up

• By: Qualied Service Technician/Homeowner

The products of combustion will contain small particles

of y-ash. The y-ash will collect in the exhaust venting

system and restrict the ow of the ue gases. Incomplete

combustion, such as occurs during startup, shutdown, or

incorrect operation of the room appliance will lead to some

soot formation which will collect in the exhaust venting

system. The exhaust venting system should be inspected at

least once every year to determine if cleaning is necessary.

The venting system may need to be cleaned at least once a

year or more often depending upon the quality of your fuel

or if there is a lot of horizontal pipe sections. Ash will build

up more quickly in the horizontal sections.

11. Cleaning the Glass

• Frequency: When clear view of the re pot is obscure

• By: Homeowner

a. Appliance must be completely cool before

cleaning glass.

b. Use a damp paper towel or any non-abrasive glass

cleaner. Wipe off with dry towel.

Handle glass assembly with care.

When cleaning glass:

• Avoid striking, scratching or

slamming glass.

• Do NOT clean glass when hot.

• Do NOT use abrasive cleaners.

• Use a hard water deposit glass cleaner on

white lm.

• Refer to maintenance instructions.

Glass

CAUTION

Fire Risk

• High ash fuels, or lack of maintenance,

can cause the re pot to overll. Follow

proper shutdown procedure if ash build up

exceeds half way point.

• Failure to do so could result in smoking,

sooting and possible hopper res.

WARNING

Handle glass with care.

• Inspect the gasket to ensure it

is undamaged.

• Do NOT strike, slam or scratch glass.

• Do NOT operate appliance with glass

assembly removed.

Glass

WARNING

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Quadra-Fire Castile - Pellet - Insert Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Quadra-Fire Castile - Pellet - Insert

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info