Bedienungsanleitung Quadra-Fire Expedition I (Seite 17 von 28) (Englisch)

815520

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

17 7094-803D 12/23

B. Cleaning the Glass & Replacement

Mostofthecarbondepositsontheglasswillburno󰀨during

hotres.

However, the ash residue that accumulates on the glass

surface should be removed regularly to prevent etching. To

cleantheglass,followthisprocedure:

• Be sure the glass is completely cool.

• Clean the glass with water or a cleaner made especially for

this purpose. Do not use abrasive cleaners. Use cleaning

agentssparinglyandbesuretokeepthemo󰀨theouter

surfaces of the stove.

• Rinse the glass thoroughly.

• Dry the glass completely.

Replace Broken Glass Immediately

Do not operate your stove if the glass in the doors is damaged.

Ifyouneedtoreplacetheglass,useonlythehightemperature

5mmceramicglasssuppliedbyQuadra-Fire.Donotuse

substitutes.

Service Part: SRV7094-054

1. Ensurethatthereisoutandtheapplianceiscooltothe

touch.

2. Protect a table or counter top with padding or towels.

Protect your hands and wear gloves to prevent injury.

3. Removethedoorwiththebrokenglassbyliftingthedoor

upando󰀨ofthehinges.

4. Laydoorfacedownonatableorcountermakingsure

thehandlehangsovertheedgesothedoorlaysat,on

a soft surface.

5. Removethescrewsfromeachglassretainerandremove

the glass. (If screws are di󰀩cult to remove, soak with

penetratingoilrst).

6. Center the glass with edges evenly overlapping the

opening in the door, (i.e. same space top and bottom,

left and right sides).

7. Replace the glass retainers. Be careful not to cross

thread the screws.

8. Tighten each retainer just a few turns until each is

secured. Check again for centering of glass in door

frame. Continue to tighten each retainer alternately, a

few turns at a time, until the glass is secure.

NOTE: DO NOT OVER TIGHTEN RETAINERS - can

causeglasstobreak.

9. Replace the door on the appliance.

Quadra-Fire appliances are equipped with ceramic super

heat-resistant glass, which can only be broken by impact

or misuse.

Injury Risk.

• Useonlyglassspeciedinmanual.

• DONOTREPLACEwithanyothermaterial.

WARNING

Handle glass assembly with care.

When cleaning glass:

Glass

Assembly

CAUTION

• Avoidstriking,scratchingorslammingglass.

• DoNOTcleanglasswhenhot.

• DoNOTuseabrasivecleaners.

• Useahardwaterdepositglasscleaneronwhitelm.

• Use commercial oven cleaner on heavier deposits.

• Remove all residue of oven cleaner or will permanently

stainglassonnextring.

Refer to maintenance instructions.

C. General Maintenance

1. Creosote (Chimney) Cleaning

• Frequency: Every 2 months during heating season

or as recommended by a certied chimney sweep;

morefrequentlyifchimneyexceedsorisunder14-16

ft. (measured from bottom of appliance)

• By:CertiedChimneySweep

Removeallashfromthereboxandextinguishallhotembers

before disposal. Allow the appliance to cool completely.

Disconnectuepipeorremoveba󰀪eandceramicblanket

fromappliancebeforecleaningchimney.Otherwiseresidue

canpileupontopoftheba󰀪eandceramicblanketandthe

appliancewillnotworkproperly.(SeeBa󰀪e Board on page

19). Close the door tightly. The creosote or soot should be

removedwithabrushspecicallydesignedforthetypeof

chimneyinuse.Cleanoutfallenashesfromtherebox.

It is also recommended that before each heating season

the entire system be professionally inspected, cleaned and

repaired, if necessary.

Inspection - Inspectthesystemattheapplianceconnection

and at the chimney top. Cooler surfaces tend to build

creosote deposits quicker, so it is important to check the

chimney from the top as well as from the bottom.

Formation and Need For Removal - Whenwoodisburned

slowly, it produces tar and other organic vapors which

combine with expelled moisture to form creosote.

The creosote vapors condense in the relatively cool

chimneyue of a newly-started or aslow-burningre.As

a result, creosote residue accumulates on the ue lining.

When ignited, this creosote creates an extremely hot re

which may damage the chimney or even destroy the house.

The chimney connector and chimney should be inspected

once every 2 months during the heating season to determine

if a creosote or soot buildup has occurred. If creosote or

soot has accumulated, it should be removed to reduce the

riskofachimneyre.

Quadra-Fire Expedition I Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Quadra-Fire Expedition I

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info