Bedienungsanleitung Quadra-Fire Outfitter I - Pellet (Seite 18 von 30) (Englisch)

815530

Zoom out

Zoom in

Vorherige Seite

1/30

Nächste Seite

18 10/238106-804K

NOTE: Quadra-Fire recommends using a heavy duty

vacuum cleaner specically designed for solid fuel

appliance cleaning.

BLOWER RETAINGING

SCREWS X6

10. Cleaning Exhaust Blower - Requires No Lubrication

• Frequency: Yearly or more frequently depending on ash

build-up

• By:HomeownerorQualiedServiceTechnician

a. Be sure the appliance is allowed to cool, has been

unpluggedandtheexhaustbloweriso󰀨.

b. Remove the left side panel.

c. Loosen the six screws holding the exhaust blower

motor to the housing and remove the motor. Using

caution as to not damage the gasket when removing

the blower. If damage occurs, install a new gasket

available as a replacement part.

d. Vacuum the blower’s impellers. Use care not to bend

ordamagetheblowerns.

e. Using a brush or vacuum attachment, clean the inside

of the exhaust outlet.

f. Reattachthemotor.Makesurethewiresareattached

to the terminals on the blower.

a. Be sure the appliance is allowed to cool and has been

unplugged.

b. Remove the right and left side panels.

c. Using phillips head screwdriver, remove screws from

both sides of the blower (4x)

d. Sweeporvacuumoutanybuild-upontheimpellers.

Use a brush or compressed air to loosen dirt if

needed.

─ Avoiddamagingtheimpellers.

8. Door Handle Inspection

• Frequency:Monthlyorpriortoheatingseason

• By: Homeowner

The gasket between the glass and rebox should be

inspected periodically to make sure there is a good seal.

9. Cleaning Convection Blower - Requires No Lubrication

• Frequency:MonthlydependingonDust/Dirtbuild-up

• By:HomeownerorQualiedServiceTechnician

7. Cleaning the Exhaust Path, Ba󰀪es & Drop Tube

• Frequency:Monthlyorevery25bagsormorefrequently

dependingonashbuild-up.

• By: Homeowner

a. Appliance must be completely cool.

b. Openthedoorandremovethecenterba󰀪erstand

thentherightandleftba󰀪es.Thoroughlyvacuumthe

exhaust path and drop tube and continue throughout

therestoftherebox.Alsovacuumthefrontandback

oftheba󰀪es.

c. Using a small brush, clean the inner walls of the

exhaustoutletfromtheaccessholeinsidetherebox.

The access hole will be visible following the removal

oftheleftsideba󰀪e.Afterlooseningupdebrisonthe

inner walls of the outlet, vacuum out.

─ This is important as the exhaust temperature

probe is attached to the right side of the outlet.

If this is not maintained on a regular basis, the

appliance will experience nuisance shut downs

and/or missed ignitions.

d. Replacetherightandleftba󰀪esandthenthecenter

ba󰀪eandcloseandlatchthedoor.

e. Clean ash from ashpans by using a vacuum or by

simply removing the ash pans located on the left and

right hand side and disposing the ashes into a metal

container.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Quadra-Fire Outfitter I - Pellet Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Quadra-Fire Outfitter I - Pellet

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info