721968
7
Zoom out
Zoom in
Vorherige Seite
1/28
Nächste Seite
7
The Quantum 4Front™ Power Chair
Your power chair has two main assemblies: the seat assembly
and the power base assembly. Typically, the seat assembly
includes the armrests, seatback, and seat base. The power
base assembly includes two motor/brake assemblies, two
drive wheels, two rear caster wheels, two front anti-tip
wheels, two batteries, and wiring harnesses. See Quantum
4Front (page 4) and figure 1.
The spring tension on your power chair was factory set
to meet the needs of the demographic majority of users.
Do not adjust the tension of any spring on your power
chair.
Electrical Components
The electrical components consist of the controller assembly,
the batteries, and the motors. The batteries, motors, and
controller power module (if equipped) are located on the
power base assembly. The controller is located on the seat
assembly. Connectivity between the controller and the
motors, batteries, and the battery charger is provided by one
or more wiring harnesses. See figure 1.
Controller Harness Connector: The controller harness
connector is where the controller plugs into the power base.
Each controller uses a different type of harness. Regardless
of which type of controller is used, the harness must be
secured to the seat assembly and not allowed to drag on
the floor.
Motor Connectors: This is where the controller connects to
the motors.
Battery Connector: This is where the controller connects to
the batteries.
Controller Power Module: This enables the controller to
communicate with the batteries and the motors.
Main Circuit Breaker (located on the right side of the
frame): The main circuit breaker is a safety feature built
into your power chair. When the batteries and the motors
are heavily strained (e.g., from excessive loads), the main
circuit breaker trips to prevent damage to the motors and the
electronics. If the circuit trips, allow your power chair to “rest”
for approximately one minute. The circuit breaker will reset
itself. Turn on the controller, and continue normal operation. If
the main circuit breaker continues to trip repeatedly, contact
your Quantum Rehab Provider.
Manual Freewheel Levers
For your convenience, your power chair is equipped with a
manual freewheel lever mounted on each motor. The levers
allow you to disengage the drive motors and maneuver the
chair manually.
To Motor
Connector
To Motor Connector
Controller Power Module
To Battery Connectors
Main Circuit
Breaker
Controller Connector
Suspension
Spring
Caster Sensor
Figure 1. Quantum 4Front Electrical Components
YOUR POWER CHAIR
Figure 2. Manual Freewheel Lever Operation
DRIVE MODE
FREEWHEEL MODE
PROHIBITED!
7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Quantum 4 Front wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Quantum 4 Front

Quantum 4 Front Bedienungsanleitung - Deutsch - 24 seiten

Quantum 4 Front Bedienungsanleitung - Holländisch - 24 seiten

Quantum 4 Front Bedienungsanleitung - Französisch - 24 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info