Bedienungsanleitung Quantum Blast (Seite 10 von 24) (Englisch)

722003

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

BLAST/REV D/OCTOBER 2002

Quantum Blast

BATTERIES

The batteries are sealed and maintenance free, so there is no need to check the electrolyte fluid level. Deep-cycle batteries

are designed to handle a longer and deeper discharge. Though they are similar in appearance to automotive batteries, they

are not interchangeable.

CAUTION! Automotive batteries are not designed to handle a long, deep discharge, and are also unsafe for use

in power chairs.

CHARGING THE BATTERIES

The battery charger is essential in providing long life for your power chairís batteries. Pride's onboard battery charger is

designed to optimise your power chair's performance by charging the batteries safely, quickly, and easily. The charging

system consists of the battery charger, the charger fuse, and the ammeter. The ammeter and charger fuse are located on the

front of the power base. See figure 4. The ammeter indicates the rate of charge being administered to fully recharge the

batteries. It is also a good indication of whether or not the charger is working. The ammeter and the charger are only functional

when the charger power lead is plugged into a wall outlet. Your power chair incorporates an inhibit function that disables the

power chair when the charger is plugged into a wall outlet.

WARNING! Never use an extension cord to plug in your battery charger. Plug the charger directly into a

properly wired standard wall outlet.

CAUTION! To ensure prolonged life, recharge your power chair's batteries with the supplied onboard or the

supplied off-board charging system. Do not use an automotive-type battery charger.

To charge the batteries using the onboard charger:

1. Position the front of the power chair close to a standard wall outlet.

2. Power off the controller.

3. Make sure that the power chair is in drive mode. See figures 7 and 8.

NOTE: Your Blast will not charge if it is in freewheel mode.

4. Plug the power lead into the chargerís AC power receptacle.

5. Plug the power lead into the wall outlet.

6. Check the ammeter. It indicates how much charge is needed to fully charge the batteries. Wait about a minute for the

charger to warm up. The ammeter needle may move as high as 5.5 amps, then gradually move back down to 0 amps as

the batteries charge. When charging the batteries for the first time, or after a long period of use, we recommend you

charge the batteries for 8 to 14 hours. As the batteries charge, the ammeter needle slowly drops to zero. When the

batteries are fully charged, the needle vibrates on or near the zero mark on the ammeter scale.

7. When your Blast's batteries are fully charged, you can unplug the power lead from the wall outlet, unplug it from the

charger AC power receptacle, and store it in a safe place.

Your power chair may be equipped with an off-board charger, one that is not built into the power chair. If you use an off-board

charger, then refer to instructions that came with the charger.

BATTERY BREAK-IN

To break in new batteries for maximum efficiency:

1. Fully recharge any new battery prior to its initial use. This brings the battery up to about 90% of its peak performance level.

2. Operate your Blast about the house and/or grounds. Move slowly at first, and don't drive too far until you become

accustomed to the controls and you break-in the batteries.

3. Give the batteries another full charge of 8 to 14 hours before operating your Blast again. The batteries should now

perform at over 90% of their potential.

4. After four or five charging cycles, the batteries top off at 100% charge and should last for an extended period.

BATTERY REPLACEMENT

WARNING! Battery posts, terminals, and related accessories contain lead and lead compounds. Wash hands

after handling.

NOTE: It is easier to connect the harnesses to the batteries when you have the batteries away from your Blast.

This gives you more room to work.

ELECTRICAL SYSTEM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Quantum Blast Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info