Bedienungsanleitung Quantum Q6 EDGE Z (Seite 32 von 44) (Englisch)

721965

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite



Care and Maintenance

Your Q6 Series is a sophisticated power chair. Like any motorized vehicle, it requires routine maintenance

checks. You can perform some of these checks, but others require assistance from your Quantum Rehab

Provider. Preventive maintenance is very important. If you follow the maintenance checks in this section

as scheduled, you can help ensure that your power chair gives you years of trouble-free operation. If

you have any doubt as to your power chair’s care or operation, contact your Quantum Rehab Provider.

WARNING! Do not service the power chair when the seat is occupied.

Your power chair, like most electrical equipment, is susceptible to damage from the elements. Avoid

damp areas of any kind.

WARNING! Direct or prolonged exposure to water or dampness could cause the

power chair to malfunction electronically and mechanically. Water can cause electrical

components to corrode and the chair’s frame to rust. Power chairs should be examined

periodically for signs of corrosion caused by water exposure, bodily ﬂuid exposure, or

incontinence. Damaged components should be replaced or treated immediately.

Should your power chair come in contact with water:

1. Dry your power chair as thoroughly as possible with a towel.

2. Allow your power chair to sit in a warm, dry place for 12 hours to allow unseen water to evaporate.

3. Check the joystick operation and the brakes before using your power chair again.

4. If any inconsistencies are found, take your power chair to a Quantum Rehab Provider. Power chairs

that are frequently exposed to sources of water, such as incontinence, should be inspected often for

corrosion and electronic components may need to be replaced frequently.

Temperature

 Some of the parts of your power chair are susceptible to extreme changes in temperature. Always

keep your power chair between the temperatures of 18°F (-8°C) and 122°F (50°C).

 In extremely cold temperatures the batteries may freeze. The speciﬁc temperature at which they

freeze depends on a number of factors, such as battery charge, usage, and composition of the

batteries (e.g., AGM or Gel-Cell).

General Guidelines

 Avoid knocking or bumping the controller, especially the joystick.

 Avoid prolonged exposure of your power chair to extreme conditions, such as heat, cold, or moisture.

 Keep the controller clean.

 Check all connectors to ensure that they are all tight and secured properly.

 Make sure pneumatic tires are inﬂated to the psi/bar/kPa air pressure rating indicated on the tire.

WARNING! Make sure your tires are inﬂated to the psi/bar/kPa air pressure rating indicated on the

tire for pneumatic tires. Do not underinﬂate or overinﬂate your tires. Low pressure may result in loss

of control, and overinﬂated tires may burst. Overinﬂating tires can cause them to explode.

WARNING! Do not use a high pressure hose to inﬂate your tires.

 Use a rubber conditioner on the tire sidewalls to help preserve them.

WARNING! Never use a rubber conditioner on the tread area of the tires; doing so may make the

tires slippery and cause your power chair to skid.

Care and Maintenance

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Quantum Q6 EDGE Z Seite 32

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Quantum Q6 EDGE Z

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info