Bedienungsanleitung Quantum Vibe (Seite 37 von 47) (Englisch)

722004

Zoom out

Zoom in

Vorherige Seite

1/47

Nächste Seite

Quantum Vibe www.quantumrehab.com 37

VI. OPERATION

Light Key

The light key turns headlights/taillights on and off independent of other indicators.

WARNING! Power chair users are required to use their lights when visibility is restricted—day or

night. Failure to use the lighting system in periods of poor visibility may result in personal injury.

Hazard Key

The hazard key toggles both indicators at the same time. You can only cancel this by pressing the hazard key again.

Battery Condition Meter

The battery condition meter is located in front of the joystick. This is a 10-segment illuminated display that indicates that the

Remote Plus is powered on and also gives the status of the batteries, the controller and the power chair electrical system.

! Red, yellow and green lights lit: Batteries charged; controller and electrical system OK.

! Red and yellow lights lit: Charge batteries if possible; controller and electrical system OK.

! Red lights only lit or slow flash: Charge batteries as soon as possible; controller and electrical system OK.

! Rapid flash of lights: Indicates a fault in the controller or the electrical system.

! Ripple up and down of lights: The joystick was not in the neutral position when the controller was turned on. If you

get “ripple up and down of lights,” turn off the controller, allow the joystick to return to the neutral position, then turn on

the controller.

NOTE: If you still get “ripple up and down of lights,” contact your Quantum Rehab Specialist.

NOTE: When the batteries approach a discharged state, the first red light will begin to slowly flash, remind-

ing you the batteries need to be charged immediately!

Speed Settings

The Remote Plus speed settings range from 1 to 5. Typically, the slowest speed setting is 1 and the fastest speed setting is

5. The settings are indicated by the number of lights that are lit on the speed setting indicator.

NOTE: The speed settings are preset at the factory. If your Quantum Rehab Specialist changes the order of these

settings, please make note of these changes. Contact your Quantum Rehab Specialist for more information.

To select a speed setting:

1. Press the on/off key to power on the remote.

2. Press the mode key once.

3. To increase chair speed, push the joystick to the right. Each time you push the joystick, you will increase the speed setting.

4. To decrease chair speed, push the joystick to the left. Each time you push the joystick, you decrease the speed setting.

5. Once you select the desired speed setting, press the mode key once to keep the setting or push the joystick in the

forward or reverse direction. The chair will resume operation at the selected speed.

NOTE: We recommend that the first few times you operate your power chair, you have your speed on the

slowest setting until you become familiar with your new power chair.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Quantum Vibe Seite 37

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info