The decaf mode allows the user to
use pre-ground decaf coffee.
To use the decaf mode press the
decaf button on the touchpad.
The front display will read
³GHFDIIHLQDWHG´
Open the door to access the brew
chamber.
Remove the brew chamber cover
shown below by sliding it up and
then pull the left side out first.
Using the provided coffee scoop
pour approximately 2 scoops of
pre ground coffee into the brew
chamber shown below.
Close the door and then press the
short or tall espresso button to
make a shot of decaf espresso.
Before steaming, purge the excess
water from the wand by hanging
the wand into the drip tray and
then press the steam button to
purge the water and then press the
steam button again to turn it off.
To use the steam wand for a
programmed dose of steam, press
the steam button once and it will
automatically shut off at the
programmed time setting.
For continuous steam, press the
steam button twice and then press
the button again when you are
done steaming to turn it off.
To program the steam button,
press and hold the button until the
GLVSOD\UHDGV³SURJUDPPLQJ´
Press the steam button again at
the desired time to stop the steam
and save the setting.
After purging the steam wand, put
the wand into the milk just below
the surface and then press the
steam button.
Position the steam tip just below
the surface until you hear a
sucking sound which is pulling air
into the milk. Continue this until the
milk reaches 100 degrees.
Then lower the steam tip a little
and position the pitcher until the
milk starts a rolling effect.
Continue this until it reaches 150
degrees. When done purge the
steam wand and then wipe with a
damp cloth.
