Bedienungsanleitung Quickie Xenon 2 FF (Seite 33 von 92) (Englisch, Holländisch, Französisch)

713880

Zoom out

Zoom in

Vorherige Seite

1/92

Nächste Seite

ENGLISH

XENON 2 FF 33 Rev.4.0

7.0 Daily Checks

CAUTION!

As the user, you are the first person to notice any possible

defects. We therefore recommend that before each use,

you check the items in the following list:

• Check for correct tyre pressures

• Check that the wheel locks work correctly

• Check that all removable parts are secure, e.g. arm rest,

footrest, quick-release axle etc.

• Check for visible damage e.g. on the frame, backrest,

seat sling and back sling, wheels, footplate etc

If there is any damage or malfunction, please contact your

authorised dealer.

8.0 Tyres and Mounting

WARNING!

Always make sure that you maintain the correct tyre pres-

sure (min. 3.5 bar) as this can have an effect on wheel-

chair performance.

If the tyre pressure is too low, rolling resistance will

increase, requiring more effort to move the chair forward.

Low tyre pressure also has a negative impact on manoeu-

vrability.

WARNING!

If the tyre pressure is too high, the tyre could burst.

The correct tyre pressure for a given tyre is printed on the

surface of the tyre (min. 3.5 bar).

Tyres can be mounted the same way as an ordinary bicy-

cle tyre.

Before installing a new inner tube, you should always

make sure that the base of the rim and interior of the tyre

are free of foreign objects.

Check the pressure after mounting or repairing a tyre. It is

critical to your safety and to the wheelchair’s performance

that regulation air pressure be maintained and that tyres

are in good condition.

9.0 Maintenance and Care

• Check the tyre pressure every 4 weeks. Check all tyres

for wear and damage.

• Check the wheel locks approximately every 4 weeks to

make sure that they are working properly and are easy to

use.

• Change tyres as you would an ordinary bicycle tyre.

• All of the joints that are critical to using your wheelchair

safely are self-locking nuts. Please check every three

months to make sure that all bolts are secure (see the

section on torque). Safety nuts should only be used once

and should be replaced after use.

• Please use only mild household cleansers when your

wheelchair is dirty. Use only soap and water when clean-

ing the seat upholstery.

• If your wheelchair should ever get wet, please dry it

afterwards.

• A small amount of sewing-machine oil should be applied

to quick-release axles approximately every 8 weeks.

Depending on the frequency and type of use, we recom-

mend taking your wheelchair to your authorised dealer

every 6 months to have it inspected by trained person-

nel.

• Exclusively use genuine Sunrise Medical spare parts.

Never use third-party parts that are not approved by

Sunrise Medical.

CAUTION !

Sand and sea water (or salt in the winter) can damage

the bearings of the front and rear wheels. Clean the

wheelchair thoroughly after exposure.

The following parts can be removed and sent back to the

manufacturer/dealer for repair:

Rear wheels-Armrest-Footrest holder-Anti-Tip tubes

These components are available as spare parts.

For further information, please see the spare

parts catalogue.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Quickie Xenon 2 FF Seite 33

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info