533865
67
Zoom out
Zoom in
Vorherige Seite
1/116
Nächste Seite
61
ESP-LXME Controller
E
The SEEF Actions screen appears, allowing you to set the
controller’s behavior when a SEEF condition exists.
A. Diagnose and Eliminate allows the controller to determine if the
high ow condition is due to a problem on the mainline (broken
pipe, stuck valve, etc) or downstream of one of the valves that
was running when the high ow condition was detected. The
controller will eliminate the high ow condition by closing the
Master Valve to eliminate a mainline problem or closing the
problem valve to eliminate a problem with a station.
B. Shut Down and Alarm instructs the controller to shut down
the Master Valve when a high ow condition is detected. The
controller will not attempt to diagnose if the problem is on the
mainline or downstream of a valve.
C. Alarm Only allows the controller to issue an alarm condition, but
take no other action.
Press the + and – buttons to set the SEEF Action; then press Next.
F
The SELF Settings screen appears with Low Flow Threshold
selected, allowing you to set the bottom limit (between 1-95%)
that a station must achieve to be considered low ow. Press the
+ and – buttons to set the Low Flow Threshold; then press Next.
Press and HOLD buttons to accelerate settings for percentages.
NOTE: Consider using the default setting of 70% (or lower) for
SEEF Low ow Threshold. Using a higher percentage can result in
false alarms due to normal hydraulic variability.
e f
G
Settling Time is selected, allowing you to set the time limit (from
3-10 minutes) that a station ow rate must remain at (or below)
the threshold before the controller will issue an alarm or take
action. Press the + and buttons to set the Settling Time; then
press Next.
H
The SELF Actions screen appears, allowing you to set the
controller’s behavior when a SELF condition exists.
A. Diagnose and Eliminate allows the controller to determine if the
low ow condition is due to a problem on the mainline (aects all
valves) or downstream of one of the valves that was running when
the low ow condition was detected. The controller will eliminate
the low ow condition by closing the Master Valve to eliminate
a mainline problem or closing the problem valve to eliminate a
problem with a station.
B. Shut Down and Alarm instructs the controller to shut down the
Master Valve when a low ow condition is detected. The controller
will not attempt to diagnose if the problem is on the mainline or
downstream of a valve.
C. Alarm Only allows the controller to issue an alarm condition, but
take no other action.
Press the + and – buttons to set the SELF Action; then press Next.
g h
NOTE: If the selected action for both SEEF and SELF is Alarm
Only, then the system is not disabled and the Delay to Re-Enable
screen will not be shown.
67

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

rainbird-esp-lxme-controller

Suche zurücksetzen

  • Wo bekomme ich einen Bedienaufkleber für Rain Bird ESP-LXME ????? Eingereicht am 21-2-2021 19:26

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für RAINBIRD ESP-LXME Controller wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von RAINBIRD ESP-LXME Controller

RAINBIRD ESP-LXME Controller Bedienungsanleitung - Deutsch - 34 seiten

RAINBIRD ESP-LXME Controller Kurzanleitung - Englisch - 1 seiten

RAINBIRD ESP-LXME Controller Kurzanleitung - Holländisch - 1 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info