Bedienungsanleitung Rascal Vision (Seite 9 von 32) (Englisch)

632982

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

5. Ignition Key: Remember to remove the key when not in use. Do

ot leave the ignition on when not in use, especially when charging

the vehicle (Fig 1). Note: You may need to press the ignition key

gently inwards before it will allow itself to be turned.

6. Finger control: To operate, turn on the ignition. Pull the right hand

ever towards you and the machine moves forward. The more you pull

the lever the faster the scooter goes. To brake, release the lever. Again

the faster the lever is released the quicker you will stop. To reverse, pull

the left lever towards you. Do not pull both levers at once. Note: The

controls can be changed for customers with a left-hand bias. Please

contact your local dealer for information.

7. Lighting control: To switch on the scooter front and rear lighting press the lighting switch once, to turn it

off, press the switch a second time.

8. Hazard lights: In an emergency or during a break-down, the hazard lights should be switched on.

Press the hazard light button once to switch on - All turn indicators will flash together. Press the button for

a second time to switch the hazard lights off.

9. Indicator (left turn): Press this once to start the left turn indicator flashing, press again to stop.

10. Half speed switch: When travelling in pedestrian areas (not on the road) this switch can be pressed to

limit the maximum scooter speed to 50% of the value pre-selected by the speed control (2) knob. This

means that the scooter will not be able to travel at more than 4mph. To turn this function off, press the

switch for a second time.

11. Indicator (right turn): Press this once to start the right turn indicator flashing, press again to stop.

12. Battery cut-out: Your scooter is equipped with a battery cut-out

(Fig 2) that is designed to operate in the unlikely event of an electrical

or electromechanical overload and is located beneath the front edge

of the seat on the black cover. If this activates, all power will be cut

from the batteries to the scooter. This device can be re-set by

pressing the button shown in the illustration. Should it activate for a

second time please seek advice from your dealer.

13. Hour meter: Your scooter is equipped with an hour meter. This

records the total time that the scooter has been run from new. This

meter cannot be reset by the user.

14. Indicator Lights/ LEDs: Along the upper edge of the dashboard there are a row of LEDs that indicate

which functions are active. As a function becomes active, a corresponding LED will light - when the

function is switched off, the corresponding LED will extinguish.

15. Temperature Indicator: This shows the current ambient temperature in degrees Celsius.

Charging Point: The charging point is situated on the left hand side

of the scooter tiller. See the Charging section for further instructions.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rascal Vision Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info