Bedienungsanleitung Rascal Vision (Seite 19 von 32) (Englisch)

632982

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Battery Charging

The charging socket is located on the upper left-hand side of the tiller. Rotate

the protective cover and push in the plug. When the vehicle is charged remove

the plug, and reposition the protective cover to keep the water out (Fig 20).

The battery charger has coloured charge status indicating LEDs / lamps (Fig 21).

When the charger is connected and switched on the first lamp will illuminate

red. If no mains power is present, no lamps will be lit. When the battery is

being charged the second lamp will illuminate orange and when this lamp

changes to green, the batteries are fully charged. Always ensure that the lamp

shows green before switching off and disconnecting the charger at the mains.

Connection Instructions

When you receive your vehicle the batteries are only partially charged –

always fully charge them before use, preferably over-night.

1. Place your machine in an area that is dry and well ventilated.

Make sure a power point is nearby.

2. Check the vehicle is switched off and the key removed.

Warning! When charging batteries NEVER smoke or charge batteries in a place where there are naked

flames such as gas-fired heaters as, under exceptional circumstances, batteries may give off gases that

could ignite and explode. If the scooter has been damaged, it is possible that the batteries have been

ffected. In this case do not charge the scooter and refer to your dealer for assistance. Never charge the

scooter outside as the charger is not designed to get wet. If the charger appears damaged in

any way do not use it and contact your dealer for a replacement.

Warning! Always charge in a dry, well ventilated area.

Warning! It is strongly recommended that the mains socket used for charging the scooter is protected

by a 30 m/A RCD (residual current device). Many buildings have sockets protected by a system based

RCD. If you are in doubt as to the level of protection in your charging location then either purchase a plug in

RCD or consult a qualified electrician to verify that your charging location mains sockets are protected.

Warning! If batteries are damaged or frozen they could heat up during charging and in an extreme case,

explode.

Warning! Do not attempt to open the battery box/enclosure, there are no user serviceable parts inside. It

may be necessary for some carriers such as airlines to physically disconnect the batteries for transit. If this

is the case the battery cover can be removed without the use of tools once the seat has been removed.

This should only be done by appropriately skilled/qualified personnel.

Warning! Never use a different battery charger to that supplied by your dealer. Damage or injury may

occur if you do!

Warning! When charging batteries NEVER connect or disconnect the charger from the scooter while it is

still connected to the mains. - Remove the charger mains plug from the wall socket having first switched

the mains socket off if a switch is provided.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rascal Vision Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info