Bedienungsanleitung Raymarine gS Series (Seite 14 von 438) (Englisch)

558427

Zoom out

Zoom in

Vorherige Seite

1/438

Nächste Seite

Memory cards and chart cards

MicroSD memory cards can be used to back up /

archive data (e.g. Waypoint, and Tracks). Once

data is backed up to a memory card old data can

be deleted from the system, creating capacity for

new data. The archived data can be retrieved at any

time. Chart cards provide additional or upgraded

cartography.

It is recommended that your data is backed up to a

memory card on a regular basis. Do NOT save data

to a memory card containing cartography.

Compatible cards

The following types of MicroSD cards are compatible

with your display:

• Micro Secure Digital Standard-Capacity

(MicroSDSC)

• Micro Secure Digital High-Capacity (MicroSDHC)

Note:

• The maximum supported memory card capacity

is 32 GB.

• MicroSD cards must be formatted to use either

the FAT or FAT 32 le system format to enable

use with your MFD.

Speed class rating

For best performance it is recommended that you

use Class 10 or UHS (Ultra High Speed) class

memory cards.

Chart cards

Your product is pre-loaded with electronic charts

(worldwide base map). If you wish to use different

chart data, you can insert compatible chart cards into

the unit's memory card reader.

Use branded chart cards and memory cards

When archiving data or creating an electronic chart

card, Raymarine recommends the use of quality

branded memory cards. Some brands of memory

card may not work in your unit. Please contact

customer support for a list of recommended cards.

EMC installation guidelines

Raymarine equipment and accessories conform to

the appropriate Electromagnetic Compatibility (EMC)

regulations, to minimize electromagnetic interference

between equipment and minimize the effect such

interference could have on the performance of your

system

Correct installation is required to ensure that EMC

performance is not compromised.

Note: In areas of extreme EMC interference,

some slight interference may be noticed on the

product. Where this occurs the product and the

source of the interference should be separated by

a greater distance.

For optimum EMC performance we recommend

that wherever possible:

• Raymarine equipment and cables connected to

it are:

– At least 1 m (3 ft) from any equipment

transmitting or cables carrying radio signals e.g.

VHF radios, cables and antennas. In the case

of SSB radios, the distance should be increased

to 7 ft (2 m).

– More than 2 m (7 ft) from the path of a radar

beam. A radar beam can normally be assumed

to spread 20 degrees above and below the

radiating element.

• The product is supplied from a separate battery

from that used for engine start. This is important to

prevent erratic behavior and data loss which can

occur if the engine start does not have a separate

battery.

• Raymarine specied cables are used.

• Cables are not cut or extended, unless doing so is

detailed in the installation manual.

Note: Where constraints on the installation

prevent any of the above recommendations,

always ensure the maximum possible separation

between different items of electrical equipment, to

provide the best conditions for EMC performance

throughout the installation

RF exposure

This equipment complies with FCC / IC RF exposure

limits for general population / uncontrolled exposure.

The wireless LAN / Bluetooth antenna is mounted

behind the front facia of the display. This equipment

should be installed and operated with a minimum

distance of 1 cm (0.39 in) between the device and

the body. This transmitter must not be co-located

or operating in conjunction with any other antenna

or transmitter, except in accordance with FCC

multi-transmitter product procedures.

FCC

Compliance Statement (Part 15.19)

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference

received, including interference that may cause

undesired operation.

FCC Interference Statement (Part

15.105 (b))

This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules.

These limits are designed to provide reasonable

protection against harmful interference in a

residential installation. This equipment generates,

gS Series

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Raymarine gS Series Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Raymarine gS Series

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info