6
1. Attach the Front Stabiliser (2) to the Frame (1) with
two M8 x 70mm Carriage Bolts (47), two M8 Curved
Washers (28), and two M8 Black Nylon Locknuts
(56). Make sure that the Front Stabiliser is turned
so the Roller (50) is not touching the floor.
2. Attach the Rear Stabiliser (3) to the Frame (1) with
two M8 x 80mm Carriage Bolts (63), two M8 Curved
Washers (28), and two M8 Black Nylon Locknuts
(56).
3. Hold the Handlebar (7) near the Handlebar Post (6).
Insert the Extension Wire (22) through the hole in the
Handlebar. Attach the Handlebar to the Handlebar
Post with three M8 x 20mm Button Screws (19) and
three M8 Flat Washers (18). Make sure that the
Extension Wire (22) is not pinched between the
Handlebar and the Handlebar Post.
2
1
56
28
63
3
3
19
18
18
22
Hole
7
6
47
28
56
1
2
50
1
4. Hold the Console Plate (8) near the Handlebar (7).
Insert the Resistance Cable (16) down into the hole
in the Handlebar and through the Handlebar Post (6).
Next, thread the Extension Wire (22) up through the
indicated hole in the Console Plate (8). Attach the
Console Plate to the Handlebar (7) with four M4 x
10mm Screws (21). Make sure that the Extension
Wire (22) and the Resistance Cable (16) are not
pinched between the Console Plate and the
Handlebar.
4
6
22
21
8
16
7
Hole
Hole
