7
11. Firmly tighten the four M8 x 31mm Button Screws
(80) in the Seat Carriage (11). Note: There are two
Button Screws in each side.
Pull the seat knob and slide the Seat Carriage (11)
to the desired position. Release the seat knob and
slide the Seat Carriage back and forth slightly
until it locks into position. Make sure to regularly
tighten the four M8 x 31mm Button Screws (80).
12. Identify the Right Pedal (37), which is marked with
an “R.” Using an adjustable wrench, firmly tighten
the Right Pedal clockwise into the Right Crank Arm
(65). Tighten the Left Pedal (not shown) counter-
clockwise into the Left Crank Arm (not shown).
After using the exercise cycle for one week,
retighten the Pedals.
Attach the Right Pedal Strap (38) to the Right Pedal
(37), and press the end of the Right Pedal Strap
onto the tab on the Right Pedal. Attach the Left
Pedal Strap (not shown) in the same way.
11
80
65
38
37
Tab
11
12
13. Make sure that all parts are properly tightened before you use the exercise cycle. Place a mat
beneath the exercise cycle to protect the floor.
10. Pull the seat knob and slide the Seat Carriage (11)
onto the Seat Rail (7).
Refer to the inset drawing. Hold the Bumper Axle
(82) inside of the Seat Rail (7). Attach the two
Bumpers (84) to the ends of the Bumper Axle with
two M6 x 16mm Button Screws (85) and two M6
Washers (25) as shown. Press the Seat Rail
Endcap (23) into the end of the Seat Rail.
11
Knob
7
10
23
82
85
84
25
25
7
9. Attach the Backrest (13) to the Seat Carriage (11)
with four 1/4” x 38mm Hex Screws (78) and four M6
Washers (25).
13
25
11
25
78
9
84
85
Knob
