16
Inspect and properly tighten all parts of the exercise
cycle regularly. The exercise cycle can be cleaned
with a soft, damp cloth. To prevent damage to the
console, keep liquids away from the console and keep
the console out of direct sunlight.
TIGHTENING THE PEDALS
For best performance, regularly tighten both pedals.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, the batteries
should be replaced. See assembly step 6 on page 7
for replacement instructions. If the console does not
display your heart rate when you use the handgrip
pulse sensor, see step 5 on page 12.
HOW TO LEVEL THE EXERCISE CYCLE
If the exercise cycle
does not sit flat on
your floor, turn one
or both of the level-
ing feet until the
exercise cycle is
level.
HOW TO ADJUST THE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is at the highest level, the
belt may need to be adjusted. To adjust the belt, first
remove all the screws from the left and right side
shields. Then, carefully remove the right side shield.
Next, turn the
indicated M8 x
40mm Screw
(58) until the
Belt (28) is
properly tight-
ened. Then,
reattach the
right side
shield.
HOW TO ADJUST THE REED SWITCH
If the console does
not display correct
feedback, the reed
switch should be
adjusted. First, use a
small flat screwdriver
to carefully pry off the
left Side Shield
Cover (14). Then,
rotate the left Pedal
Guard (8) and move it away from the left side shield.
Next, locate
the Reed
Switch (69).
Turn the Left
Crank Arm (15)
until the
Magnet (23) is
aligned with
the Reed
Switch.
Loosen, but do
not remove,
the indicated
M4 x 16mm
Screw (66).
Slide the Reed Switch slightly closer to or away from
the Magnet. Then, retighten the Screw. Turn the
Crank Arm for a moment. Repeat until the console
displays correct feedback. When the Reed Switch is
correctly adjusted, reattach the Pedal Guard (8) and
the left Side Shield Cover (14).
MAINTENANCE AND TROUBLESHOOTING
Leveling
Feet
69
66
23
15
14
8
58
28
