Bedienungsanleitung Reer 50133 Care and talk (Seite 15 von 57) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

716181

Zoom out

Zoom in

Vorherige Seite

1/57

Nächste Seite

28 29

Before ﬁrst use

BLACK

RED

Insert Battery

1. Remove the belt clip. Pull the eye and pull the belt

clip downward.

2. Open the battery compartment by releasing it and

removing the screw with a screwdriver and with

light pressure and a parallel sliding movement

downward, remove the compartment.

3. Carefully connect the Li-Ion battery plug to the

female connector in the battery compartment (red

lead on the right).

4. Insert battery into device. Both cables should be

between battery and male connector.

5. Slide the cover back onto the battery compartment back and screw it on again.

6. Connect the two chargers with the power supplies that are included in the purchase and

plug them into a 230 V outlet.

7. Place the devices into the charger. During charging, the line blinks on the charg-

ing status indicator light and the light on the charger is red.

Warning: Before ﬁrst use, fully charge both devices until the charging status light shows 3

lines. During ﬁrst charging, this can last 4 hours.

When the battery is fully charged, the message „FULL“ appears on the display.

You can also charge the battery without a charger directly via the micro USB charging con-

nector on the device.

2 in 1: baby monitor or walkie talkie operating modes

Do not forget that due to the two functions of the device, this instruction manual consists

of two chapters. In the ﬁrst part (chapter 1) you will ﬁnd instructions on how to use the

devices in the baby monitor mode; the second section provides information on how to use

your device as a transmitter (a normal PMR 446 hand-held radio) that you or your children

may later want to use.

Chapter 1: Use in „baby monitor“ operating mode

Cable microphone

For use as a baby monitor, an external microphone also forms part of the package. Using

this cable microphone has the following advantages: it is more sensitive than the built-in

microphone and can capture sounds from a greater distance. In this way you can extend

the distance between the child unit and the baby‘s bed. This greatly reduces radiation in the

child‘s proximity. In addition, you can place the child unit in such a way as to achieve the

best possible reach - for example, on the bedside or a cupboard.

Warning: If you use Care&Talk as a baby monitor, always connect the cable microphone.

Installation of child unit

Attach the supplied cable microphone near the baby‘s bed, but out of reach of your child. To

secure the microphone securely use the supplied adhesive tape and then secure the cable

with the supplied cable clips and cable guides. Open

the rubber cover for connectiong accessories (MIC/

EAR connector) on the right side of the device, and

plug the male cable microphone connector into the

top female connector.

Standard settings

Turn on the devices by pressing the power switch for

about 3 seconds. Check standard settings. You will ﬁnd

precise information about each setting in the next chapter.

Child unit (star motif):

• Baby mode:

• Channel: 01b

• Sensitivity control: VOX

• Talk Back function: OFF

Parent unit:

• Parental mode:

• Channel: 01P

• Range control:

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Reer 50133 Care and talk Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info