Bedienungsanleitung Rel stampede (Seite 16 von 20) (Englisch)

413310

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

REL Acoustics ST 5 User Manual

Hint: There is a tendency among audiophiles to set the crossover point too high and the gain

too low when first learning how to integrate a REL with the system, the fear being one of

overwhelming the main speakers with bass. But in doing so, the resulting set-up will be

lacking in bass depth and dynamics. The proper crossover point and gain setting will increase

overall dynamics, allow for extended bass frequencies, and improve soundstage properties.

Please note: gain must be adjusted in conjunction with crossover changes. In general, when

selecting a lower crossover point, more gain may need to be applied.

Theatre and Film Applications:

For DolbyDigital or other surround sound theatre systems,

once the standard set-up for two-channel outlined above is complete, the LFE output from the

processor or receiver should be connected to the low-level input and appropriate gain

adjustments made. Keep phase consistent with what was selected during high-level set-up.

For this configuration, you must set the processor to the “large” or “full range” setting for the

left and right speakers in order for the REL to receive the bass signal via the high-level cable.

In this setting, the REL provides support for both the left and right speakers for two-channel

listening, and support for the LFE when movies are playing. Most processors will allow you to

defeat the subwoofer output when listening in the two-channel mode, however, if this is not

the case, simply press LFE Mute on the remote (or via the control panel) and save the setting

to memory for future stereo use. The effect of this set-up is one of greatly increased dynamics

in the mid-bass range; no bass bloat; and a greater degree of space and timing from the

Foley effects. For an even greater sense of space and impact, a second woofer connected in

parallel to the centre channel will prove to be a dramatic improvement as well. And if that is

not enough for you, a rear sub, both to support the rear channel speakers as well as to evenly

distribute LFE through the room, truly completes the full-range sonic picture for state-of-the-

art film reproduction.

Some rooms, notably in houses of wooden construction, can sound bass “light”. To

overcome this disadvantage, the new RELs offer variable Slam and Depth. Simply adjust the

+ and – buttons marked Slam and Depth on the remote, or navigate to the display using the

front panel encoder and adjust to compensate for the room. Of course, some rooms,

especially smaller brick built ones, may be bass heavy at around the mid bass area, in which

case reduce this effect by again using the Slam and Depth control.

Remember that all these settings can be saved into memory.

Note: Some processors output a signal from their LFE socket, even when playing a CD in

Stereo mode. In the past little could be done, now using the remote, simply mute the LFE.

This is recommended for Stereo mode listening and can be saved along with the other

options.

Other Tips:

Generally speaking, do not use the supplied spikes. RELs work on the principle

of the driver being in a high-pressure zone relative to the floor. Spiking the REL will decouple

the woofer from the floor, which will lean out the bass response. If the floor is an older, very

“springy” floor, spikes can be useful in reducing the influence of the REL on the floor. A

heavy stone slab under the REL will further improve performance. Even if you intend to use

the spikes, do NOT insert them until completion of the set-up process. After which, subtle

adjustments to crossover and gain may be necessary

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rel stampede Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info