Bedienungsanleitung Remington HC7150 (Seite 7 von 150) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

719584

Zoom out

Zoom in

Vorherige Seite

1/150

Nächste Seite

AFTER EACH USE

• Ensure the appliance is switched o and unplugged from the mains before cleaning.

• Brush the accumulated hair from the blades and body of the clipper. Do not submerge

the clipper in water.

• To clean unit, wipe with a damp cloth and dry immediately.

• Place a few drops of cutter or sewing machine oil onto the blades. Wipe o excess oil.

WASHABLE BLADE CLEANING

• To remove the blades ensure the unit is o. Press the blade release button on the back

of the clipper where it meets the blade and push away from the clipper.

• To reattach once the blades are cleaned and dry, align the bottom of the blade with the

bottom blade housing tab and slide the cartridge back into place until you hear a click.

• Do not run the entire unit under the tap, only the blade set is meant to be submerged in

water.

• Place a few drops of cutter or sewing machine oil onto the blades. Wipe o excess oil.

EVERY SIX MONTHS

• Remove the 2 screws retaining the xed blade with a screwdriver.

• Remove the blade set.

• Brush out hairs from between the blades with a soft cleaning brush. Do not remove the

lubricating grease from the blades. It is not necessary to remove the small moving blade

from the unit.

• If the moving blade has been removed this can be re-tted by slotting the moving

blade holder over the pin in the centre of the interior product head.

• The groove on the moving blade just below the teeth should rest on the plastic pressure

arm which rides inside the groove. The xed blade should be assembled with the

bevelled edge of the 2 screw holes facing outward and xed with screws.

• Note that if the blades are not correctly aligned then cutting eciency will be impaired.

CLEANING CAUTIONS

• Cleaning should only be done with a soft brush, such as the brush supplied with the

product.

• Do not rinse under water.

• Do not use harsh or corrosive cleaners on the units or their blades.

• Ensure the appliance is switched o and unplug from the main outlet before cleaning.

REMOVING THE RECHARGEABLE BATTERY

We strongly recommend that a professional removes the rechargeable battery. Parts of the

shaver case, and tools have sharp edges and may cause injury if not handled correctly.

• The rechargeable battery must be removed from the appliance before it is scrapped.

• Disconnect the charging adapter before removing the battery.

1. Ensure that the battery is fully discharged. To do this, operate the trimmer until it stops.

ENGLISH

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Remington HC7150 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info