ENGLISH
10
Single Flash Mode
1.Placethei-LighthandpieceagainstyourskinsotheFlashWindowisush
with the skin surface (fig. 8).
2.EnsuretheSkinContactSensorisfullyengagedandtheBulbStatusIndicator
Display is illuminated.
3. Press the Flash Button to activate the device (fig. 9).
4. Move the hand piece to a new treatment area and repeat steps 1-3 (fig. 10).
Treat desired area(s) with the i-Light device –
Multi Flash Mode
1.Placethei-LighthandpieceagainstyourskinsotheFlashWindowisush
with the skin surface (fig. 8).
2.EnsuretheSkinContactSensorisfullyengagedandtheBulbStatusIndicator
Display is illuminated.
3.PressANDHOLDtheFlashButtondowntoactivatethedevice(g.9).
4.Immediatelyafterthedevicehasashed,slidethehandpiecetoanew
location.Afterashortdelay(approximately2seconds)thedevicewillash
again (fig. 10).
Note:
• DuringMulti-FlashMode,theSkinContactSensorANDtheFlashButtonmust
remain fully depressed. If either becomes disengaged, the device will not
operate. To resume treatment, repeat steps 1-4.
• DuringMulti-FlashMode,theBulbStatusIndicatorDisplaywillremain
illuminatedwhiletheSkinContactSensorandFlashButtonareengaged.
Treatment Tips
• Forbestresults,avoidoverlappingashes.Thishelpspreventexposureto
more energy than is necessary to suppress hair growth. It also ensures that you get the maximum use
of the light cartridge.
• Forthemosteectiveresults,alwaysusethehighestintensitylevelthatdoesnotcausediscomforton
the skin. The level you use should feel warm on your skin, but should never cause discomfort.
• Optimalresultsaregenerallynotobtainedwithasinglesession.Forbestresults,repeatatreatment
session whenever you notice hair starting to regrow. Results vary by individual, however, most people
will treat areas every two weeks for the first three treatments, until desired results are achieved.
• Youmaynoticethatbonyareas,suchaselbows,shins,andankles,aremoresensitiveduring
treatment. This is normal and should not be cause for alarm. To avoid this sensitivity, try stretching the
skin away from the bony area during treatment.
