Bedienungsanleitung REMKO ASF100 (Seite 6 von 16) (Englisch)

587877

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

REMKO ASF 100

Prior to each commissioning

or as required, the air inlet and

outlet grilles must be checked for

clogging.

Important information

prior to commissioning

■

All electrical extension cables

must have a sufﬁcient cross-

section and only be used fully

uncoiled.

■

Do not pull at the power cord.

■

After switching on, the units

operate fully automatically until

switched off controlled by the

timer or ﬂoat switch of the full

condensate container.

■

The condensate container must

be ﬁtted correctly.

The unit will not function if the

condensate container is not ﬁt-

ted correctly!

■

For safety reasons, the units are

ﬁtted with a tilt switch which

prevents operation of a unit

that has toppled over or is lying

vertically.

The unit can only be restarted

when it is placed upright!

■

In an unsupervised continuous

mode with external condensate

connection, the produced con-

densate is continuously drained

via a hose connection on the

condensate container.

Commissioning

Control panel

The control panel contains control

buttons and indicator lights.

➊ ON / OFF

The unit is switched on and off

with this button.

Note switch off delay of about

2 minutes.

➋ MODE

This button is used for selecting

the 3 modes “POWERFUL”,

“SILENT” and “NORMAL”.

➌ TIMER

This button is used to activate

the switch off timer for 2, 4 or 8

hours.

➍ AUTO SWING

This button is used to activate

the automatic swing mode of

the air directing ﬂap.

➎ IONIC

This button is used to switch

on the ioniser for enriching

the room air with negatively

charged ions.

➏ ”FULL TANK” indicator light

This indicator light shows when

the condensate container is full

and requires emptying. When

the unit is switched off via the

ﬂoat switch, the unit generates

5 audible signals.

Safety information

The units were subjected to ex-

tensive material, functional and

quality inspections and tests prior

to delivery.

However, the units may constitute

a hazard if used by untrained per-

sonnel, improperly or not for the

intended purpose.

The following information must

be observed:

■ The units must not be installed

and operated in hazardous

areas.

■ The units must not be installed

and operated in oil, sulphur,

chlorine or salt containing

atmospheres.

■ The units must be installed up-

right and stable.

■ The units must not be exposed

to direct water jets.

■ The air openings must always be

kept free.

■ The air inlet grilles must always

be kept free of dirt and loose

objects.

■ The units must not be covered

during operation.

■ Never insert foreign objects into

the units.

■ The units must not be transport-

ed during operation.

■ The units must only be trans-

ported upright.

■ The condensate containers must

be emptied prior to each change

of location.

➊

➋➌

➍

➎

➏

NOTE

Clogged grilles and ﬁlters must

immediately be cleaned or

replaced.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

REMKO ASF100 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von REMKO ASF100

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info