587705
10
Zoom out
Zoom in
Vorherige Seite
1/28
Nächste Seite
The unit has been manufactured using state-of-the-art production methods and tested several times to ensure its
correct function. If malfunctions should occur, please check the unit as detailed in the list below. For installations
with an indoor unit and outdoor unit, refer to the chapter "Troubleshooting and customer service" in both
manuals. Please inform your dealer if the unit is still not working correctly after all the functional checks have been
performed!
Troubleshooting and customer service
Malfunction
The unit is running
with reduced or no
cooling output.
Exchange refrigerant lines
Are the injection pipes and
suction pipes of circuits A, B and
C correspondingly connected?
Check by a specialist
Exchange the electrical control
cable
Are the control pipes and
refrigerant pipes of circuits
A, B and C correspondingly
connected?
Check by a specialist
Air inlet and/or air outlet are
blocked by debris.
Debris in air inlet and air outlet
area?
Clean the fins.
Reduce the air resistance.
Thermal or wind load
was increased.
Have there been any
constructional / application-
related changes?
Reduce the thermal/wind loads
by implementing appropriate
measures.
No heat output possible.
Is the fan on the outdoor unit
running?
Fan / winter controller should be
checked.
Leaking refrigerant circuit
Are there signs of severe frost
on the large stop valve?
Repair by a specialist.
Fault Possible cause Check Remedial measures
The unit does not start
or switches itself off.
Power outage, undervoltage
Are all electrical installations
functioning correctly?
Check voltage if necessary wait
before switching back on
Defective mains fuse
Main circuit breaker is open
Are all lighting circuits
functioning correctly?
Replace mains fuse
Close main circuit breaker
Damaged mains cable
Are all electrical installations
functioning correctly?
Repair by a specialist
Waiting time after switch-on too
short
Is there a restart after approx. 5
minutes?
Schedule longer waiting periods
Temperature outside operating
range
Are the fans in the unit still
working?
Observe the temperature ranges
Occasional overvoltage or
undervoltage
Check by a specialist
Turn the equipment off and back
on
Switch-off contact in external
condensation pump has opened
Is the external condensation
pump on the indoor unit
"faulty”?
Clean the condensation pump
drain
Have the pump replaced
The suction pipe and /
or liquid separator on
the compressor have
iced up
Thermal load has increased
Is the outdoor unit running
continuously?
Reduce the thermal load If
necessary, install an additional
device / insulate iced up
components
REMKO MVT
10
10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für REMKO MVT600 DC wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von REMKO MVT600 DC

REMKO MVT600 DC Bedienungsanleitung - Deutsch - 24 seiten

REMKO MVT600 DC Bedienungsanleitung - Deutsch - 28 seiten

REMKO MVT600 DC Bedienungsanleitung - Holländisch - 28 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info