726617
26
Zoom out
Zoom in
Vorherige Seite
1/48
Nächste Seite
NOTICE!
If condensate is removed via a duct in accord-
ance with DIN EN 1717, ensure that any micro-
biological contamination present on the waste-
water side (bacteria, fungi, viruses) cannot
enter the unit connected to it.
8 Electrical wiring
8.1 General notes
A protected power supply cable is to be connected
from the outdoor unit to the indoor unit, and a pro-
tected three-core control line is to be connected to
the indoor unit respectively
.
DANGER!
All electrical installation work is to be performed
by specialist companies. Disconnect the power
supply when connecting the electrical terminals.
NOTICE!
The electrical connection for the units must be
made at a separate feedpoint with a residual
current device in accordance with local regula-
tions and should be laid out by an electrician.
n W
e recommend that a main/repair switch be
installed close to the unit. This must be pro-
vided by the customer.
n The terminal blocks for making the connections
are located at the rear of the unit. When the
unit is installed, measurements can be made
from the front by removing the cover.
n If an optional condensate pump is used as an
accessory in conjunction with the unit, it may
be necessary to install an additional relay with
a higher contact rating after the switch-off con-
tact on the pump to switch off the compressor.
The control line to the outdoor unit contains data
cables which serve to realise the communication
between the indoor unit and the outdoor unit. This
is used for controlling the cooling and heating
capacity and for forwarding alarm codes to the
indoor unit.
Make the connection as follows:
1. Open the unit cover
.
2. Loosen the covers on the right side using a
cross screwdriver
. (Fig. 18).
3. The connection options for the power supply
and control lines are located under the cover
.
4. Connect the control line provided by the cus-
tomer to the terminals P
,Q and E.
5. Connect the control line provided by the cus-
tomer to the indoor units and outdoor unit in
a professional manner (also terminals P
, Q
and E). If the installed indoor unit is the last
one in the connection sequence, the 120
Ohm resistor supplied must be installed
between the terminals P and Q.
6. Then close of
f the cover and the unit cover.
Fig. 18: Connecting the indoor unit
1: Cover
2: Strain relief
3: Terminal block for control line
4: Control line from outdoor unit
REMKO MVW series
26
26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für REMKO MVW 452 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von REMKO MVW 452

REMKO MVW 452 Bedienungsanleitung - Deutsch - 48 seiten

REMKO MVW 452 Bedienungsanleitung - Holländisch - 48 seiten

REMKO MVW 452 Bedienungsanleitung - Französisch - 48 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info