587720
10
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
HEATING
MODE
Heating mode operational sequence
> 6 Min.> 3 Min.
> 6 Min.
30 sec. 30 sec.
Nominal temperature
+5 °C
Nominal temperature
+2 °C
Fan operation IT
Fan operation AT
Compressor operation AT
Actual
temperature Stop Heating mode
Heating mode
Start Heating mode
Functional diagram
Operation
Stop
Reverse flow valve
30 sec. 30 sec.
During the defrosting cycle, the indoor unit vaporiser fan and the
outdoor unit liquefier fan are switched off.
After the cycle is concluded, the fans are switched to their previous
settings.
< 7 Min.
Defrost period
15 sec. 60 sec.
Fan operation IT
Fan operation AT
Compressor operation AT Operation
Stop
Reverse flow valve
30 sec. 30 sec.
30 sec. 3 Min.
OR
Hr.
ON TIM ER
Hr.
Off TI MER
SET TEMP
Tur bo
MODE
Hr.
ON TIMER
Hr.
Off TIMER
Tur bo
SET TEMP
Hr.
ON TIM ER
Hr.
Off TI MER
SET TEMP
Auto
Tur bo
In the heating mode, you can simultaneously heat all of the rooms in
spring or fall. The desired room temperature is set with the /buttons
in 1 °C increments. If the room temperature is 1 °C below the selected
target temperature, the indoor unit starts to heat the air in the room.
The inverter controller checks the difference between the adjusted target
temperature and the actual room temperature.
In the event of a greater difference, a higher cooling performance is
created.
In the event of a smaller difference, a lower cooling performance is
created.
This serves to maintain the air discharge temperature and the room
temperature.
If the set room temperature is exceeded by approx. 2 °C, then the
control system turns the heating function off. To protect the compressor,
the regulation only turns the heater on again after a waiting period of
3 minutes.
In heating mode, the indoor unit fan motor is switched on after a delay,
in order to prevent the discharge of cold air.
The fins on the outdoor unit could crack at low outdoor temperatures.
Regular reversal of the cooling circuit results in a defrosting action. The
display shows "H1" during the defrosting period.
HEATING Mode
Hr.
ON TIMER
Hr.
Off TIMER
SET TEMP
Turbo
FAN
Heating mode has priority!
If an indoor unit switches
over to heating mode, then
cooling is switched off for the
other indoor devices in cooling
mode.
Cooling is not possible during
heating operation.
CAUTION
REMKO MXW
10
10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für REMKO MXW200 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von REMKO MXW200

REMKO MXW200 Bedienungsanleitung - Deutsch - 24 seiten

REMKO MXW200 Bedienungsanleitung - Holländisch - 24 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info