Bedienungsanleitung REMKO RKL470 (Seite 6 von 16) (Englisch)

587572

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

3 "COMP. ON" display (compressor is running)

When the compressor is started again for a second

time, a minimum of three minutes must elapse be-

forehand for safety reasons. During this time, the

"COMP ON" display blinks.

4 "THERMO CONTROL" button (temperature selection)

After the unit has been connected to the power supply

and manually switched on, the target temperature is

automatically set to 25°C. This can be changed using

the arrow buttons in 1°C increments between 20 and

30°C:

Left arrow button = Higher target temperature

Right arrow button = Lower target temperature

This is shown in display 7.

Control Panel

The unit may only be put into operation once it has been

installed following all instructions contained in the “Safety

Hints” and “Installation Instructions” sections.

1 "On / Off" button

2 "MODE" button (operating mode and fan setting)

There are 5 options available. Display 10 shows the

selected operating mode.

The sequence is: AUTOHIMEDLOFAN

AUTO Cooling mode, automatic fan rotation inde-

pendent of room temperature.

HI Cooling mode, highest fan setting.

MED Cooling mode, medium fan setting.

LO Cooling mode, lowest fan setting.

FAN Ventilate only, no cooling.

5 "TIMER" button (timer clock)

The timer can be preset for a maximum of 24 hours.

The amount of time is shown on display 7. The timer

has two functions:

1. Unit switches on automatically

When the unit is off, using the "SET" button, the user

can enter the number of hours after which the unit is

to be switched on. Each time the button is pressed,

the number of hours is increased by 1. If this func-

tion is activated, "TIMING ON" 9 is lit up

After the timer has been activated, the operating

mode and target temperature can be set as de-

scribed above.

2. Unit switches off automatically

When the device is on, using the "SET" button, the

user can enter the number of hours after which the

device is to be switched off. Each time the button is

pressed, the number of hours is increased by 1. If

this function is activated, "TIMING OFF" 9 is lit up.

Fig. 3

FAN LO MED HI AUTO

COMP. ON

THERMO CONTROL

MODE I / O

2 3 4

7 10 1

TIMER

TIMING

OFF

SET RESET

AUTO

SWING

DRAIN WATER

REMOTE

5 6 11

8 7

Fig. 4

To disable the timer or change the setting, press

the "RESET" button.

Information about the timer:

◊ If the "On / Off" button is pressed when the timer is

set to switch the device off, this setting is cleared

and the unit switches off.

◊ If the "SET" button is pressed while the timer is acti-

vated, the remaining time is shown on the display.

Each time the "SET" button is pressed, the remain-

ing time is increased by one hour.

6 "AUTO SWING" button

Pressing this button activates the automatic motion

of the horizontal plate fins on the air outlet grill.

Pressing this button again stops this motion.

The "AUTO SWING" function can be deactivated by

repeatedly pressing this button in quick sequence to

adjust the direction of the horizontal air outlet.

Never adjust the horizontal plate fins manually!

7 Display

Normally, the target temperature is displayed here. If

the thermo control button or the TIMER button is

pressed, the display switches for 5 seconds to the

corresponding setting.

8 REMOTE-SENSOR (sensor remote control)

The unit receives the signals sent from the infrared

remote control via the "REMOTE SENSOR".

Special accessory for RKL 460.

9 "TIMING ON" display

If this display is lit up, the unit will automatically be

switched on after a preset amount of time.

9 "TIMING OFF" display

If this display is lit up, the unit will automatically be

switched off after a preset amount of time.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

REMKO RKL470 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von REMKO RKL470

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info