656688
4
Zoom out
Zoom in
Vorherige Seite
1/6
Nächste Seite
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent
the technical status at the time of printing.
© Copyright 2014 by Conrad Electronic SE.
Operation
Connect a consumer load to the “front socket” (B).
Please consult the section “Technical Data” for the consumer load’s permis-
sible maximum power.
By using the “ON” or “OFF” button for the switching channel, on the handheld trans-
mitter, the radio controlled socket is turned on/off again, using the same set switching
channel (control-LED (A) lights up or turns off).
Maintenance and Care
The product does not require any maintenance and should never be opened or disas-
sembled for any reason.
Remove connected consumer loads from the radio controlled switch socket and re-
move it from the mains socket, before cleaning the product.
Only clean the product with a soft, clean, dry cloth. Never use aggressive cleaning
agents or chemical solutions since these could damage the surface of the casing or
impair operation.
Handling
The radio-controlled switch socket is only intended to be used in dry,
closed indoor locations.
Avoid the following unfavourable environmental conditions at the installa-
tion location and during transportation:
- Direct sunlight
- Extreme cold or heat
- Dust or flammable gases, fumes or solvents
- Strong vibrations
- Strong magnetic fields such as those found in the vicinity of machinery
or loudspeakers
Ensure that the insulation for the entire product is neither damaged nor
destroyed. Never disassemble the product! There are no serviceable
parts inside.
Check the product for damage before each use!
If you recognize damages do no longer use the product!
There is danger to life through an electric shock!
Safe operation must be presumed to be no longer possible:
- the device is visibly damaged
- if the device no longer works
- if the device was stored under unfavourable conditions for a long period
of time
- it has been subjected to considerable stress during transportation
Range
The transmission range of the radio signals, between the handheld transmitter and the
radio controlled switch sockets, is up to 30 m under optimum conditions.
This value, however, is the so-called “open space range” (the range the
transmitter and receiver are visible to each other, without disturbing influ-
ences).
In practical operation, however, there are walls, ceilings of rooms, etc. be-
tween the transmitter and the receiver, which reduce the range accordingly.
Due to the different influences on the wireless transmission, no specific
range can be guaranteed.
However, trouble-free operation is usually possible in a single family house.
Sometimes the range can be considerably reduced due to:
Walls, reinforced concrete ceilings
Coated/metallised insulated glass
Proximity to metallic & conductive objects (e.g., heating elements)
Proximity to human bodies
Broadband interferences, e.g., in residential areas (DECT telephones, mobile
phones, radio controlled headphones, radio controlled speakers, radio controlled
weather stations, baby phones, etc.)
Proximity to electric motors, transformers, power-supply units, computers
Proximity to computers or other electrical devices that are improperly shielded or
operated without any cover
Disposal
Please dispose of the device, when it is no longer of use, according to cur-
rent statutory requirements.
Declaration of Conformity (DOC)
We, Conrad Electronic, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declare that
this product conforms to the fundamental requirements and the other relevant regula-
tions of the directive 1999/5/EC.
The Declaration of Conformity for this product is available at
www.conrad.com.
Technical Data
Reception frequency ................. 433 MHz
Operating voltage....................... 230 V/AC, 50 Hz
Protection class ......................... I
Input power ................................. 2000 W Ohm resistive load, 300 W inductive load
Address codes............................ 4 (adjustable by turn switch)
Switching channel ..................... Adjustable with turn-switch “1 2 3 4”
LED................................................ lights up, when the mains socket/consumer load is ac-
tivated
Dimensions (H x W x D)............. 95 x 51 x 73 mm (incl. connection plug)
....................................................... approx. 95 x 51 x 35 mm (not including connection plug)
Operating environment ............. only suitable for enclosed, dry indoor locations
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Renkforce 1208457 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info