Bedienungsanleitung Renkforce RF100 XL (Seite 10 von 64) (Englisch)

692203

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

• If you have questions which remain unanswered by these operating instructions, contact our technical

support service or other technical personnel.

b) Setup

• Place the 3D printer on a level, horizontal surface of a sufcient size.

• Install the 3D printer in a location that is out of the reach of children.

• Ensure that the power switch on the printer is easily accessible so that you can switch it off quickly in

the event of a fault.

• Do not expose the printer to extreme temperatures, strong vibrations, high humidity (e.g. rainwater or

steam) or strong mechanical loads.

• Never place containers (e.g. glasses or vases) lled with liquid on or directly next to the printer or pour

liquids over the appliance. Liquids may come into contact with the interior components and impair the

electrical safety of the product or cause a re or fatal electric shock.

If the printer comes into contact with liquids, isolate the mains socket (e.g. switch off the circuit breaker

and RCD), and then unplug the mains plug from the mains socket. Disconnect all cables from the printer.

Discontinue use and take the printer to a specialist repair centre.

• Do not place open ames (e.g. burning candles) on or next to the printer.

c) Mains cable/connection

• The mains socket that the printer is plugged into must be easily accessible.

• Only power the product using the mains adapter provided.

• Only insert the mains adapter into a standard mains socket that is connected to the public grid. Before

plugging in the power adapter, check whether the voltage stated on the power adapter complies with the

voltage of your electricity supplier.

• Fully unwind the mains cable before use, otherwise the cable may overheat and cause a re!

• Never connect or disconnect the power adapter if your hands are wet.

• Never unplug the power adapter from the mains socket by pulling on the cable. Always use the grips

on the plug.

• Make sure that the mains cable is not squeezed, bent, damaged by sharp edges or subjected to

mechanical stress. Avoid excessive thermal stress on the mains cable from extreme heat or cold. Do not

attempt to modify the mains cable, as this may cause permanent damage. Damaged mains cables can

cause a fatal electric shock.

• Do not allow the mains cable to hang over the edge of the table or other surface supporting the 3D

printer.

• Always lay the cables so that nobody can trip over or become entangled in them, as this may cause an

injury.

• For safety reasons, disconnect the power adapter from the mains socket during storms.

• Unplug the power adapter if you do not plan to use the 3D printer for an extended period.

• Always disconnect the power adapter before leaving the printer unattended.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Renkforce RF100 XL Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Renkforce RF100 XL

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info