Bedienungsanleitung Renkforce RF1000 (Seite 4 von 114) (Englisch)

536366

Zoom out

Zoom in

Vorherige Seite

1/114

Nächste Seite

2. Explanation of Symbols

The symbol with a lightning bolt in a triangle is used where there is a health hazard, e.g. from electric shock. The device

contains no parts that require servicing by the user. Therefore, never open the device.

The exclamation mark symbol indicates that the user must read these operating instructions before commissioning of

the device, and observe them during operation.

This symbol warns of hot surfaces the contact with which may cause injury.

This symbol warns of hand injury that may occur when reaching into the device in operation.

The symbol with the arrow indicates special advice and notes.

3. Intended Use

The 3D printer produces 3D-objects from suitable printing ﬁles. For this, suitable raw material (ﬁlament) is melted in the print head

and attached in the required position for the object.

This product is only approved for connection to 100-240 V/50/60 Hz alternating current

It is intended for indoor operation only. Do not use it outdoors. Contact with moisture, e.g. in bathrooms, must be avoided under

all circumstances.

Any use other than that described above will damage this product and involves the risk of short circuit, ﬁre, electric shock, etc.

This product complies with the statutory national and European requirements. All company names and product names are trade

ATTENTION Mains voltage - the connection, installation and wiring of the electrical components must only be perfor

med by an electrician who is familiar with the applicable safety provisions. Before commissioning, inspection accor-

ding to the applicable safety provisions must be performed by an electrician.

Observe all safety and assembly notes in these operating instructions!

4. Safety Information

The guarantee/warranty will expire if damage is incurred resulting from non-compliance with these operating instruc-

tions. We do not assume liability for any consequential damage.

Nor do we assume any liability for damage to property or personal injury caused by improper use or failure to observe

the safety information. In such cases the warranty/guarantee is voided.

Dear Customer: The following safety information is intended not only for the protection of the device but also for the

protection of your health. Please read through the following attentively:

• For safety reasons, any unauthorized conversions and/or modiﬁcations to the product deviating from these operating

instructions are not permitted. Components may be damaged and thus impair the function or safety of the device.

• When setting up the 3D printer, observe that the mains switch at the rear of the device must be easy to reach so that

the device can be switched o quickly and easily in case of malfunction.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Renkforce RF1000 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Renkforce RF1000

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info