Bedienungsanleitung Respekta CH 77090SA (Seite 21 von 28) (Deutsch, Englisch)

793448

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

English Installation- and Operating Instruction Cooker Hoods

7.1 Changing the grease filter

Grease filters must occasionally be changed. The

following rules apply:

 Change paper grease filters monthly

 Change paper grease filters with alarm every two

months or when the colour of the surface becomes

visible through the mesh openings. This filter is

coloured on one side; after fitting, this colouring

must not be visible through the mesh openings.

 Foam grease filters must be soaked once a month

in warm soapy water for 1 to 2 hours. Do not wring

out; repeat where required and replace the filter by

a new item after a maximum of 5-6 washes.

 Metal grease filters do not have to be replaced

when they are over-saturated but washed once a

month by hand or in a dishwasher (60°) (please do

not use a corrosive rinsing agent). Allow the filter to

dry thoroughly and carefully replace it in the

extractor hood.

Avoid using alkaline dishwasher cleaning

agents (ph value over 7).

 Carbon filters

a) Traditional carbon filters (normally round in

shape) can be neither washer nor regenerated.

The charcoal filters have to be replaced regularly,

at least every 3 months or earlier, depending on

the cooking habits

b) Washable and regeneratable carbon filters

(normally square in shape) are to be washed

once a month in a dishwasher, using a standard

rinsing agent and with the intensive rinsing

program (at the highest temperature).

Washable and regeneratable carbon filters absorb

kitchen odours for a maximum of 3 years when

cleaned monthly. The filter should then be

replaced by a new item.

Washable and regeneratable carbon filters

should be washed separately to avoid food residue

deposits which can later cause unpleasant odours.

After washing, the washable and regeneratable

carbon filter must be reactivated. This is carried out

by drying the cleaned filter in an oven for 10 minutes

at 100°C.

Read the package to see whether your carbon filter

is washable and regeneratable.

If the package carries no information, then it contains

a traditional, non-washable carbon filter.

fi200909

Each time you change or wash a grease filter or

carbon filter, after removal clean all exposed lower

parts of the hood with a mild grease solvent.

For the daily cleaning of the outer pats of the hood

use a soft cloth moistened with alcohol or a mild liquid

cleaner. Never use an abrasive cleaner.

There is a risk of fire if the instructions for

cleaning the hood and the changing or cleaning of

the filters are not complied with.

8. Changing the lamps

When changing a lamp, make sure that the

new lamp does not have a higher wattage than that

of the original.

8.1 Changing LED lamp

If the documentation of the cooker hood does not

include an instruction for replacing LED lamps, the

lamp must pe replaced by the customer service for

safety reasons.

See also chapter "Customer Service"

9. Fault – what to do if ...

The motor fails to function:

Is the plug properly inserted in the socket?

Is there a power supply failure?

Has a fuse blown?

The hood capacity is insufficient / operating

noise has increased:

Is the size of the exhaust air pipeline sufficient?

Is the exhaust air duct blocked?

The cross section of the air pipeline (from the hood

to the wall box incl.) should be 120 mm.

A smaller air pipeline cross-section can possibly

impair the motor power.

The air flow can be obstructed if the wall box is

fitted with a fly mesh.

If this is the case remove the fly mesh.

If the cover plate of the wall box has fixed, very

inclined louvres, you should remove the plate to

check whether this solves the problem.

Mount a cover plate with movable louvres in the

wall box, as this will least obstruct the air flow.

Is / are the filter(s) clean?

Was / were the carbon filter(s) installed more than

six months ago?

Then this/these should be changed.

Is the air taken from the kitchen being replaced by

sufficient fresh air, so that no partial vacuum is

being produced in the room?

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Respekta CH 77090SA Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info