black steel
Problem Possible caus Solution
Temperature regulation knob is set at coldest Set the knob at other switch on the appliance.
Mains plug is not plugged in or is loose Insert mains
Fuse has blown or is defective Check fuse, replace if necessary
Socket is defective Mains malfunctions are to be corrected by an electrician
Appliance
freezes or cools
too much
Temperature is set too cold or the appliance runs
at coldest.
Turn the temperature regulator to a warmer setting
temporarily.
Temperature is not properly adjusted. Please look in the initial Temperature Setting section.
Door was open for an extended period. Open the door only as long as necessary.
A large quantity of warm food was placed in the
appliance within the last 24 hours.
Turn the temperature regulation to a colder setting
temporarily
The appliance is near a heat source. Please look in the installation location section.
Heavy build up
of frost on the
door seal
Door seal is not air tight.
Carefully warm the leaking sections of the door seal with
a hair dryer (on a cool setting). At the same time shape
the warmed door seal by hand such that it sits correctly.
Appliance is not level. Re-adjust the feet.
The appliance is touching the wall or other objects. Move the appliance slightly.
A component, e.g. a pipe, on the rear of the
appliance is touching another part of the appliance
or the wall.
If necessary, carefully bend the component out of the
way.
Water on the
floor Water drain hole is blocked. See the Cleaning and Care section.
Side panels are
hot. It’s normal. Heat exchange parts are in the sides. Take gloves to touch sides if needed.
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data here, refer to the rating plate.
3UREOHPVKRRWLQJ
Caution" Before troubleshooting, disconnect the power supply. Only a qualified electrician of competent
person must do the troubleshooting that is not in this manual.
Important" There are some sounds during normal use (compressor, refrigerant circulation).
Appliance does
not work
The food is not
frozen enough.
Unusual noises
*%
fi200603 13
