Bedienungsanleitung Respekta PYRO 9 TOUCH (Seite 55 von 71) (Deutsch, Englisch)

792895

Zoom out

Zoom in

Vorherige Seite

1/71

Nächste Seite

6、Self-cleaning function

In the function to be selected mode, select the self-cleaning mode. The default temperature

is not adjustable. The default working time is 1:00 hours. It can be adjusted by using “+” or

“ ” time. The working time range is minimum 1 hour, maximum 2 hour.

After setting the working time under the self-cleaning mode , touch “ ” to start working.

At this time,“ ” shows, door lock activates, the “ ” and “ ”displayed constantly. At

this point, the oven door is locked, the oven self-cleaning function is activated, and the

“ ” can be pressed to pause the function.

After confirming that the self-cleaning function is activated, the clock position displays the

working time countdown and the temperature position displays“ ”.

After the self-cleaning function is activated, door lock function is automatically opened and

the oven door is locked. At this time, the self-cleaning gear starts to work. If the self-

cleaning function is activated, the program automatically prompts the error code and the

display shows “E-3”. For specific cause analysis, please refer to the part of “protection

function 11.5.3~11.5.4”. You can press and hold the power key“ ” to cancel the error code

and the program returns to the standby state. After troubleshooting, reset the self-cleaning

function, and then press the “ ” key to start working.

7、Attentions for self-cleaning function

7.1 Before use of the self-cleaning function, all the accessories such as the wire rack, oven

pan and side shelves must be taken out of the oven, otherwise the high temperature will

damage the fittings.

7.2 After using the self-cleaning function, do not use water or other washing agents.

7.3 After use the self-cleaning function, you may find matter which was not removed in the

side of the cavity, this is normal. Use a microfiber cloth to clean them.

7.4 In order to achieve a better self-cleaning effect ,you can take out the all accessories of

the oven and cleaning the oven simply before using the self-cleaning function.

7.5 Before using the self-cleaning function, it is necessary to remove too much food residue

and oil in the oven for cleaning. Because too much food residue and oil inside of the oven

will be burned when the temperature in the oven is too high, which is very dangerous. Will

produce a large smoke and irritating odor during the self-cleaning work process.

7.6 When using the self-cleaning function, the external glass surface temperature is very

high. Do not touch the case and glass surface with your hands to prevent burns. Children

must be kept away from the oven to avoid burns.

7.7 When the seal of oven is found to be poor effect or damaged, other sealing strips should

not be used instead. Special sealing strips should be replaced in time so as not to affect the

effect of each function.

8、Door lock function

8.1 Door lock display: After the self-cleaning is finished,the system enters into the standby

mode.When the oven cavity temperature are higher than 280,the screen displays the icon

“”(See pic 9). The door lock is automatically unlocked when the oven cavity temperature

is below 280 ,and the door lock icon“ ”will disappear.See pic 10.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Respekta PYRO 9 TOUCH Seite 55

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info