Bedienungsanleitung Ricoh PJ WX5361N (Seite 8 von 206) (Englisch)

639315

Zoom out

Zoom in

Vorherige Seite

1/206

Nächste Seite

Important Information

CAUTION

• Do not use the tilt-foot for purposes other than originally intended. Misuses such as gripping the tilt-foot or hang-

ing on the wall can cause damage to the projector.

• Do not send the projector in the soft case by parcel delivery service or cargo shipment. The projector inside the

soft case could be damaged.

• Select [HIGH] in Fan mode if you continue to use the projector for consecutive days. (From the menu, select

[SETUP] → [OPTIONS(1)] → [FAN MODE] → [HIGH].)

• The projector's power cannot be turned off, even if you turn off the power switch, while the Power indicator is

ickering blue. Do not turn off the AC power to turn off the power while the Power indicator is ickering blue. Doing

so may cause the lamp to explode or may greatly shorten the lamp's life.

Remote Control Precautions

• Handle the remote control carefully.

• If the remote control gets wet, wipe it dry immediately.

• Avoid excessive heat and humidity.

• Do not short, heat, or take apart batteries.

• Do not throw batteries into re.

• If you will not be using the remote control for a long time, remove the batteries.

• Ensure that you have the batteries’ polarity (+/−) aligned correctly.

• Do not use new and old batteries together, or use different types of batteries together.

• Dispose of used batteries according to your local regulations.

Note for US Residents

The lamp in this product contains mercury. Please dispose according to Local, State or Federal Laws.

Lamp Replacement

• Use the specied lamp for safety and performance.

• To replace the lamp, follow all instructions provided on page 155.

• Be sure to replace the lamp and lter when the message [THE LAMP HAS REACHED THE END OF ITS USABLE

LIFE. PLEASE REPLACE THE LAMP. USE THE SPECIFIED LAMP FOR SAFETY AND PERFORMANCE.]

appears. If you continue to use the lamp after the lamp has reached the end of its usable life, the lamp bulb may

shatter, and pieces of glass may be scattered in the lamp case. Do not touch them as the pieces of glass may

cause injury.

If this happens, contact your dealer for lamp replacement.

A Lamp Characteristic

The projector has a high-pressure mercury lamp as a light source.

A lamp has a characteristic that its brightness gradually decreases with age. Also repeatedly turning the lamp on

and off will increase the possibility of its lower brightness.

The actual lamp life may vary depending upon the individual lamp, the environmental conditions and usage.

CAUTION:

• DO NOT TOUCH THE LAMP immediately after it has been used. It will be extremely hot. Turn the projector off

and then disconnect the power cord. Allow at least one hour for the lamp to cool before handling.

• When removing the lamp from a ceiling-mounted projector, make sure that no one is under the projector. Glass

fragments could fall if the lamp has been burned out.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ricoh PJ WX5361N Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Ricoh PJ WX5361N

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info