780478
37
Zoom out
Zoom in
Vorherige Seite
1/42
Nächste Seite
37
8. GETTING HOME WHEN SOMETHING
BREAKS
Unless you're going for a short ride in the neighborhood, or you can
walk home or call someone to pick you up if something breaks, you
should never go for a bike ride without the following emergency
equipment:
• 4mm, 5mm and 6mm Allen wrenches, used to tighten various
clamping bolts that may loosen
• Patch kit and a spare inner tube
• Tire levers
• Tire pump or cartridge inflator with correct head to fit your tire
valves (see Section 6.7.2)
• Some kind of identification (so people know who you are in case of
an accident)
• Spare cash (for a candy bar, cool drink or emergency phone call)
8.1. If you get a flat tire:
Depress the tire valve to let all the air out of the tube (see Section
6.7.2).
Remove the wheel from the bicycle (see Section 6.1.3 or 4).
Remove one bead of the tire from the rim by grasping it at a point
opposite the valve stem with both hands and, at the same time, lifting
and peeling one side of the tire off the rim. If the bead is on too tight
for you to unseat it with your hands, use tire levers to lift the bead
carefully over the tire rim. Remove the valve lock nut (if the valve has
one) and push the valve stem through the wheel rim.
Remove the inner tube.
Carefully check the outside and inside of the tire for the cause of the
puncture and remove the cause if it is still there. If the tire is cut, line
the inside of the tire in the area of the cut with something handy -
tape, a spare patch, a piece of inner tube, a candy wrapper -
whatever will keep the cut from pinching the inner tube.
Either patch the tube (follow the instructions in your patch kit), or use
a new one.
WARNING: Patching a tube is an emergency repair. Careless
patching or applying several patches can seriously weaken the tube,
resulting in possible tube failure, which could cause you to lose
control and fall. Replace a patched tube as soon as possible.
Reinstall the tire and tube. Slip one tire bead over the rim. Insert the
tube valve through its hole in the rim, but don't secure it with the
locknut yet. Feed the tube carefully into the cavity of the tire. Inflate
the tube just enough to give it some shape. Starting at the valve stem
and working around both sides of the rim to the side opposite the
valve stem, use your thumbs to push and seat the other bead of the
tire inside the rim. Be careful not to pinch the tube between the tire
bead and the wheel rim. If you have trouble getting the last few
inches of bead over the edge of the rim with thumb pressure, use a
tire lever and be careful not to pinch the tube.
CAUTION: If you use a screwdriver or any tool other than a tire
lever, you are likely to puncture the tube.36 37
37

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Ridley City Bike wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info