Bedienungsanleitung Riho Whirlpool Electronic LCD (Seite 9 von 28) (Englisch)

626525

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Z1209004. 5 GB

Enjoy the RIHO life-style

Whirlpool Electronic LCD user handbook

- Thanks to the non-porous, smooth surface of the material, dirt will not or will hardly stick to the material.

Maintenance can be limited by cleaning the bath after use with a wet sponge or cloth and a liquid cleaner (without

abrasive material).

- The repair of small cracks and similar damage to the bath.

If you want to repair minor damage, due care is recommended. You may proceed as follows:

If there are fine scratches, it will be adequate to use a chrome and lacquer polisher (solvent and abrasive free). If the

result of this is not satisfactory, you may sand off the damage with waterproof sandpaper no. 600 and then with

waterproof sandpaper no.1000. Reprocess with a chrome and lacquer polisher for a perfect end-result and your bath

will be as good as new.

A complete set may be obtained from Riho International bv (Article no.: ).

You may repair your bath yourself at your own risk.

- Major damage, deep scratches, holes and even cracks may be repaired and can almost be made to disappear. It is

recommended that these should be repaired by specialised technicians.

REP400

All Riho baths are made of acrylic (polymethyl methacrylic) and supported in the bottom with chipboard and reinforced

with glass fibre polyester.

Acrylic is a plastic and coloured all the way through.

The properties of acrylic provide the user with the maximum bathing comfort, provided the appropriate installation and

maintenance instructions are duly followed.

2.0 Riho Acrylic (PMMA) baths (Whirlpools)

3.0 Maintenance

Fig. 6:

1.5.4 Hot and cold water supply.

The supply pipelines may be installed on the rim of the bath or on the wall for connection to the bath tap. A drainage

overflow installation with water supply can also be supplied. Ask your dealer for Riho overflow-drain combinations with

water supply in the bath.

In case of installation of a drainage overflow installation with water supply in the bath, an aerator water supply should

be installed in the supply line. This is to prevent dirty water from flowing back into the supply pipeline.

In case of doubt, consult a plumbing specialist.

1.5.5 Water drain

Connect the drain pipeline with siphon to the bathroom drain pipeline (min 40 mm). The bathroom drain pipeline must

be positioned at around 25-35 cm from the centre line of the bath's drain, and should have sufficient drainage so that

adequate drainage is ensured (see fig. 6). In case of doubt, consult a plumbing specialist.

Maximum allowable water temperature is 60°C

Figure 5 Inspection hatch(es).

1.5.6 Electrical connection

1.5.7 Potential difference equaliser

The metal frame of the whirlpool must have a potential difference connection. For this purpose a special metal

connector suitable for an earth cable of 2.5 mm² to 6mm² is fitted to the frame.

The electrical supply for the installation should be provided with suitable cable using a fixed junction box suitable for

environment. For this purpose, the whirlpool is delivered with a 3x1.5mm² or 5x2.5mm² cable with a red warning label

(5x2,5mm² if with heater or Thermae line).

Connection of the whirlpool should be made to one group of 230V/50HZ in case of cable 3x1.5mm² or two groups

(combined on-off) of 230V/50Hz in case of cable 5x2.5mm². Each cable must be secured by a suitable circuit breaker

10A (cable 3x1.5mm² ) or 16A (cable 5x2.5mm²) normally with characteristic C.

An earth leakage circuit breaker of 30mA as well as a potential difference equilisation 4-6mm² on whirlpool frame are

obligatory part of the installation. The local electricity rules and regulations must be met. In case of doubt, consult your

plumbing specialist.

-37--36-

Elektrická

skříňka

Elektrická

skříňka

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Riho Whirlpool Electronic LCD Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Riho Whirlpool Electronic LCD

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info