Bedienungsanleitung Rika Contina (Seite 17 von 24) (Englisch)

744639

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

|17

Adding wood

Fill amount for heating up: 2 logs of max� total 2�5kg, depending on

requirements�

The red ﬂashing phase varies depending on the ambient inﬂuences

between 5 and 10 min� If the combustion chamber door is opened,

the display changes to green ﬂashing�

If the temperature increase is sufﬁcient (wood added and lit), the

display changes to constantly green (the RIKATRONIC3 starts the

burn-off control)�

If an increase in temperature in not detected, the display changes,

depending on combustion chamber temperature, to the status prior

to adding wood, either to red ﬂashing or to constantly red.

Burn out

If no more wood is added during the red ﬂashing phase, the display

changes to constantly red� No more logs may be added from this

point since ignition of any logs added cannot be ensured� The stove

must be heated up again�

ECO operation

If the room to be heated and the stove are already at temperature,

continued operation with lower heat output and log addition is

possible�

Fill amount in ECO operation: 2 logs in total approx� 1�5kg

If the Eco key is pressed when adding wood (after closing the

combustion chamber door), the display changes to yellow ﬂashing

and Eco operation is activated�

This operating mode also regulates the burn off with lower heat

output to the optimum�

If the Eco key is pressed again or the combustion chamber door is

opened, the display changes from yellow back to green and normal

operation is activated again�

Complete closing of the air flaps

The RIKATRONIC3 has a safety device that prevents the air ﬂaps

closing completely during heating operation (hazard of deﬂagration)�

However the air ﬂaps can be closed completely with a sequence of

ECO key and opening and closing the combustion chamber door to

stop the existing draught on stove standstill�

Q Ensure that the stove has cooled down, is switched off and that

the combustion chamber door is closed

Q Plug in the mains plug and activate the main switch at the rear

of the stove

Q Wait until the reference run has been completed and the display

lamp is constantly red

Q Now depress the ECO key for 5 sec with the combustion chamber

door closed until the display changes to yellow ﬂashing

Q Open and close the combustion chamber door, the display is now

constantly yellow

Q The depress the Eco key again for 5 sec until a click is heard and

the air ﬂaps close completely

As soon as the air ﬂaps reach end position, the display goes off and

the stove can be switched off and the mains plug disconnected�

Power failure

In the event of a power failure the air regulation ﬂap remains

unchanged until the ﬁre goes out (no display)� If mains voltage is

available again after a brief power failure, the display lights up as

on start for 10 sec green and then changes to red ﬂashing due to the

repeat reference run of the air ﬂap motor�

If the temperature of the stove is still more than 80°C, the display

changes and the control system changes to the respective status�

If the stove cools back down during the power failure, the display

changes to constantly red

Manual regulation

Note

Manual operation may only be performed with the unit switched off�

Any other procedure than that stated below may cause damage to

components and inevitably leads to loss of warranty�

Q Switch the stove off at the main switch and disconnect the mains

plug�

Q Insert the socket spanner supplied sufﬁciently far into the sleeve

as shown�

Symbolfoto

Turning clockwise opens the air ﬂaps; anti-clockwise closes them�

Q Turn the socket spanner ﬁrst to heating-up position (open until a

stop is detected)�

Q Turn the socket spanner gradually anti-clockwise after the

heating-up phase to control the air intake and thus the burn-off

manually�

Symbolfoto

Note

Always ensure that the stove is supplied with sufﬁcient air for

combustion; otherwise increased smoke development may occur�

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rika Contina Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Rika Contina

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info