Bedienungsanleitung Rika Forma (Seite 12 von 16) (Englisch)

744641

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

6. MANUAL OPERATION

Operating the riddle grate

The ash is moved from the combustion chamber to the ash drawer by pushing

the riddle grate handle back and forth. This frees the way for the primary air

intake which is necessary for heating up.

In general the riddle grate should stay open. The air regulation is made

completely with the front air control knob.

Combustion air regulation

The performance of your stove also depends on the chimney draught; therefore

the control know must be used according to your own experience.

The “heating-up position“ may only be used for heating up.

If the stove is not in use, warm air can release through the chimney. The zero

setting of the control knob can largely prevent this.

Note

Sometimes a lot of smoke develops when wood is placed on a low ﬁrebed or

when there is too less fresh air for combustion. An explosive gas/air mixture

may arise and cause an eventual heavy deﬂagration. For safety reasons it is

recommended to leave the combustion chamber door closed and press the

control knob at the rear wall down completely into “heating-up position”. If the

log wood is not igniting, start a new heating-up procedure after it stopped

smoking.

RIKA firelighter

Always ignite the RIKA ﬁrelighter on the red tip. One block consists out of 8 ribs

which can be divided to the desired size. The amount of RIKA ﬁrelighters also

depends on the size and humidity of your ﬁrewood. Ideally, one rib is enough

to light up the ﬁre.

Tip

You can order the RIKA ﬁrelighter with the number E15834 at your RIKA

dealer.

Correct heating up

1. Press the control knob completely into “heating-up position”. Open the

combustion chamber door and sweep the ashes into the ashtray. Then open

the riddle grate completely.

Place left and right two small pieces of chipboard lengthways in the bottom of

the combustion chamber.

Place two logs crossways on top of this chipboard. (see AMOUNT of FUEL)

2. Now place further pieces of chipboard in crosswise layers on top of the

logs and place 2-4 ribs of the RIKA-ﬁrelighter on top of the chipboard. Some

uncoated paper can be placed underneath the chipboard in case there is no

ﬁrelighter available.

3. Now light the ﬁrelighter (or the uncoated paper) and close the combustion

chamber door. Correct heating up primarily counteracts excessive smoke

during heating up.

Set the air control knob to middle position some minutes later.

Another few minutes later (depending on draught and fuel quality / amount), the

control knob can be set further to zero setting to reduce the air intake.

Realimentation

After the ﬁrst burn-off, add two logs again. Set the controll to “heating-

up position” again until the wood is well lit. Further regulation is effected as

described in Item 3.

Please proceed in the same way for every further addition of wood. To decrease

see AMOUNT of FUEL - part load.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rika Forma Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Rika Forma

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info