Bedienungsanleitung Rika Induo II (Seite 10 von 28) (Englisch)

744678

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Prior to set up

Floor bearing capacity

Ensure that the substructure is capable of bearing the weight of the stove prior

to set-up.

Note

No modiﬁcations may be made to the ﬁring installation. This also leads to loss

of warranty and guarantee.

Floor protection

A glass, sheet steel or ceramic plate is required, if the ﬂoor is combustible

(wood, carpet, etc.).

Flue pipe connection

QFlue pipes pose a particular source of hazard regarding gas leaks and

ﬁre. Get the advice of an authorised specialist company for the layout and

assembly.

QPlease observe the corresponding installation guidelines for walls panelled

with wood when connecting your ﬂue pipes to the stove,

QObserve the formation of ﬂue gas (atmospheric inversion) and draughts

when the weather is unfavourable.

QInfeed of too little combustion air can lead to smoke in the rooms or to ﬂue

gas leaks. Hazardous deposits in the stove and chimney may also occur.

QIf ﬂue gas escapes, let the ﬁre burn out and check whether all the air inlet

openings are free and the ﬂue gas pipes and the stove pipe are clean. If in

doubt notify the master chimney sweep since draught malfunctions may be

connected to your chimney.

Convection air conduction

only for stoves with MultiAir

The MultiAir equipped stove is delivered with a cover on the convection air outlet

to prevent direct heat to the wall.

Operation without this cover or without attached convection pipes is not

allowed. If you do though no warranty and no liability is accepted for damage.

QThe amount of air and temperature of one fan is designed to heat one

additional room.

QNote the regional speciﬁc ﬁre safety regulations and clarify the connection

situation with the competent authority

QThe max. temperature of the convection air is 180 °C at the air outlet.

QThe convection air canal should be as short as possible.

QKeep the number of deﬂections as small as possible.

Note

Please pay attention to the national and country-speciﬁc building and ﬁre

regulations when connecting the convection air pipes. Installation and

assembly must be performed by a trained specialist only.

Stoves type 1 (BA 1):

QThese may only be operated with the combustion chamber door closed.

QSuitable for multiple occupancy. (note the different country regulations)

QThe combustion chamber door may only be opened to add fuel and must

then be closed again otherwise other ﬁring installations connected to the

chimney may be endangered.

QThe combustion chamber door is to be kept closed when the stove is not

in operation.

QFouling of the chimney i.e. deposits of highly inﬂammable materials such as

soot and tar and subsequently ﬁre in the chimney may occur if the chimney

is miscalculated and dimensioned wrong and if wet wood is used.

If ﬁre in the chimney occurs, disconnect the mains plug of the stove. Phone the

ﬁre brigade and get yourself and other residents out of harm’s way.

Note

Due to the size of the combustion chamber door it is necessary not to

open the door abruptly, to prevent the ﬂames coming out. Especially when

reheating into blazing ﬂames.

Note

on ROOM-AIR DEPENDENT and

ROOM-AIR INDEPENDENT OPERATION:

Your stove has been tested as a room-air independent stove according to

EN13240 and to EN14785 and can be installed as well room-air dependent

and independent. In Germany it does not conform to the requirements for

room-air independent operation.

When installed room-air dependent in combination with room-air installations

(e.g. controlled ventilation and venting systems (extractors etc.) it must

be ensured that the stove and the room air system are monitored and

safeguarded mutually (e.g. via a differential pressure controller etc.).

The combustion air infeed of approx. 20 m3/h must be ensured.

Please observe the respective local regulations and rules in consultation with

your master chimney sweep. For changes after the printing of this manual, we

can not assume any liability. We reserve the right to change without notice.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rika Induo II Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Rika Induo II

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info