Bedienungsanleitung Rika Interno (Seite 14 von 20) (Englisch)

744681

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

7. MAINTENANCE AND CLEANING

The frequency with which the stove requires cleaning and the

maintenance intervals depend on the fuel you use. High moisture

content, ash, dust and chips may more than double the maintenance

required. We would like to point out again that only tested and

recommended pellets may be used as fuel.

Note

Ash may contain embers – only place ash in sheet steel containers.

FIRE RISK! In a cold state, dispose it of in the household waste.

Note

We recommend at least once a year to have all maintenance

carried out by your RIKA dealer.

Open combustion chamber door and

pellet container

Open the decorative door. To open the combustion chamber door

and the pellet container use the provided key.

Note

Remove the key after the OPEN / CLOSE of the combustion

chamber door or the pellet hopper immediately to avoid accidental

damage to the decorative door glass!

Cleaning of the burn pot - daily

Make sure that the air vents are not blocked with ash or clinker.

Remove the clinker using the supplied brush and vacuum the burn

pot. The burn pot can be easily cleaned inside the stove. After

removing the pot the area underneath can be vacuum-cleaned.

Do not damage the ignition when cleaning with the brush. Vacuum

out the pipe of the ignition.

Note

Clean the ﬁre trough regularly. Only clean when stove is cold, when

embers are extinguished!

Note

If the stove is heated in continous operation, it must be cleaned 2x

within 24 hours. FIRE HAZARD!

Cleaning the flame temperature sensor

Remove the dust deposits from the sensor at regular intervals. Use a

clean cleaning cloth or newspaper.

Cleaning the door glass

The viewing window becomes coated in the case of solid fuels,

particularly with the very ﬁne ash of wood pellets, light or dark

depending on the pellet quality (especially with low output). The

glass can be cleaned best with a moist cloth. Stubborn dirt can be

removed with a special cleaner available from your stove dealer.

Usual cleaners containing acid or solvents can be too harsh and

damage the glass.

Cleaning painted surfaces

Wipe the painted surfaces with a damp cloth, do not scrub. Do not

use solvent-containing cleaners.

Cleaning

Depending on pellet consumption, a message prompting cleaning of

the stove appears on the display in regular intervals. This message

can be acknowledged on the Touch Display, while continuing

operation. Perform a cleaning cycle at the next opportunity.

Subsequently, reset the counter in the SETTINGS menu / RESETS

submenu, as per operating instructions of TOUCH DISPLAY.

Tip

The message will only stop reappearing once you have reset the

feed volume in the SETTINGS / Resets menu.

Note

Your stove must be switched off and cooled before any maintenance

work is performed. Only work on the unit when the mains plug has

been disconnected.

Cleaning flue pipes

The ﬂue pipes should be cleaned at least 2x a year or after approx.

700 kg pellets. The ﬂues are behind the combustion chamber.

Open the decorative glass door.

Disconnect the power plug from the mains.

Close the decorative glass door and remove the two retaining screws.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rika Interno Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Rika Interno

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info