Bedienungsanleitung Rika Look RLU (Seite 10 von 24) (Englisch)

744638

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Prior to set up

Floor bearing capacity

Ensure that the substructure is capable of bearing the weight of the

stove prior to set-up�

Note

No modiﬁcations may be made to the ﬁring installation� This also

leads to loss of warranty and guarantee�

Floor protection

A glass, sheet steel or ceramic plate is required, if the ﬂoor is

combustible (wood, carpet, etc�)�

Flue pipe connection

Q Flue pipes pose a particular source of hazard regarding gas leaks

and ﬁre� Get the advice of an authorised specialist company for

the layout and assembly�

Q Please observe the corresponding installation guidelines for walls

panelled with wood when connecting your ﬂue pipes to the stove�

Q Observe the formation of ﬂue gas (atmospheric inversion) and

draughts when the weather is unfavourable�

Q Infeed of too little combustion air can lead to smoke in the rooms

or to ﬂue gas leaks� Hazardous deposits in the stove and chimney

may also occur�

Q If ﬂue gas escapes, let the ﬁre burn out and check whether all the

air inlet openings are free and the ﬂue gas pipes and the stove

pipe are clean� If in doubt notify the master chimney sweep since

draught malfunctions may be connected to your chimney�

Stoves type 1 (BA 1):

Q Suitable for multiple occupancy� (Note the different country

regulations�)

Q These may only be operated with the combustion chamber door

closed�

Q The combustion chamber door may only be opened to add fuel

and must then be closed again otherwise other ﬁring installations

connected to the chimney may be endangered�

Q The combustion chamber door is to be kept closed when the

stove is not in operation�

Q Fouling of the chimney i�e� deposits of highly inﬂammable

materials such as soot and tar and subsequently ﬁre in the

chimney may occur if wet fuel is used and operation is damped

too much�

Q If this occurs, close the fresh air support (slider,

regulator, ﬂaps - depending on model)! Disconnect

the mains plug at the stoves type Rikatronic�

Phone the ﬁre brigade and get yourself and other residents out

of harm’s way�

Note

on ROOM-AIR DEPENDENT and ROOM-AIR INDEPENDENT

OPERATION:

Your stove has been tested as a room-air independent stove

according to EN 13240 and can be installed as well room-air

dependent and independent�

When installed room-air dependent in combination with room-

air installations (e�g� controlled ventilation and venting systems

(extractors etc�) it must be ensured that the stove and the room

air system are monitored and safeguarded mutually (e�g� via a

differential pressure controller etc�)� The combustion air infeed of

approx� 20 m3/h must be ensured�

Please observe the respective local regulations and rules in

consultation with your master chimney sweep� For changes after

the printing of this manual, we can not assume any liability� We

reserve the right to change without notice�

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rika Look RLU Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Rika Look RLU

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info