Bedienungsanleitung Rika Look RLU (Seite 20 von 24) (Englisch)

744638

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

8. CLEANING AND MAINTENANCE

Basic information

Note

When you vacuum clean around the stove ensure that you do not

vacuum into the combustion air intake during heating operation�

You could vacuum out embers – FIRE RISK!

Note

Your stove must be cooled before any maintenance work is

performed�

Type RIKATRONIC3: Only work on the unit when it is switched off

and the mains plug has been disconnected�

The frequency with which the stove requires cleaning and the

maintenance intervals depend on the fuel you use� High moisture

content, ash, dust and chips may more than double the maintenance

required� Only use wood that has been stored properly and is dry

and untreated�

The stove should be cleaned thoroughly prior to the start of the

heating season to prevent excess odour�

Tip

Wood as fertiliser - the mineral content of the wood remains in the

combustion chamber as ash as a residue of the combustion� This is

an excellent fertiliser for all plants in the garden; it is a completely

natural product� The ash should be stored ﬁrst and slaked with

water�

Note

Ash may contain embers – only place ash in sheet steel containers!

Cleaning the combustion chamber

The combustion chamber must be regularly cleaned from ash to

ensure an adequate supply of air� If you remove the grate, you can

sweep the ashes with a broom in the ash tray� You can also use an

ash vacuum cleaner�

Note

Only when the stove is cold! You could vacuum out embers – FIRE

RISK!

Empty the ash drawer

Empty the ash drawer regularly� The ash drawer is simply pulled

forward with the combustion chamber door open�

Cleaning the flame temperature sensor

(only type RIKATRONIC3)

Remove the dust deposits from the sensor at regular intervals� Use a

clean cleaning cloth or newspaper�

Combustion air - intake

If necessary, please also clean the air intake with a hoover�

Note

Only when the stove is cold! You could vacuum out embers – FIRE

RISK!

Cleaning the door glass

The glass can be cleaned best with a moist cloth� Stubborn dirt can

be removed with a special cleaner (free from corrosive acids and

solvents - otherwise there is a risk of damage to the glass surface)

available from your stove dealer� Usual cleaners containing acid or

solvents can be too harsh and damage the glass�

Note

Never use abrasive or aggressive cleaning agents to clean the

wooden door handle, these will damage the wood�

Cleaning painted surfaces

Wipe the painted surfaces with a damp cloth, do not scrub� Do not

use solvent-containing cleaners�

Cleaning the flue pipes

Annually!

Remove the ﬂue pipes� Inspect and clean the chimney connection�

Brush off any soot and dust deposits in the ﬁre and in the ﬂue pipes

and vacuum�

Note

Accumulated ﬂy ash in the ﬂue gas channels may impair the

performance of the stove and pose a safety risk�

Checking door seal

Annually!

The condition of the seals at doors and glass should be checked at

least once a year� Repair or replace seals depending on condition�

Note

Only intact seals ensure your stove works perfectly!

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rika Look RLU Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Rika Look RLU

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info