Bedienungsanleitung Rika Look (Seite 8 von 16) (Englisch)

744637

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

Prior to set up

Floor bearing capacity

Ensure that the substructure is capable of bearing the weight of the stove prior

to set-up.

Note

No modiﬁcations may be made to the ﬁring installation. This also leads to loss

of warranty and guarantee.

Floor protection

A base is required (glass, sheet steel or ceramic) if the ﬂoor is combustible

(wood, carpet, etc.).

Flue pipe connection

Q Flue pipes pose a particular source of hazard regarding gas leaks and

ﬁre. Get the advice of an authorised specialist company for the layout and

assembly.

Q Please observe the corresponding installation guidelines for walls panelled

with wood when connecting your ﬂue pipes to the stove.

Q Observe the formation of ﬂue gas (atmospheric inversion) and draughts

when the weather is unfavourable.

Q Infeed of too little combustion air can lead to smoke in the rooms or to ﬂue

gas leaks. Hazardous deposits in the stove and chimney may also occur.

Q If ﬂue gas escapes, let the ﬁre burn out and check whether all the air inlet

openings are free and the ﬂue gas pipes and the stove pipe are clean. If in

doubt notify the master chimney sweep since draught malfunctions may be

connected to your chimney.

Stoves type 1 (BA 1):

Q Suitable for multiple occupancy. (Note the different country regulations.)

Q These may only be operated with the combustion chamber door closed.

Q The combustion chamber door may only be opened to add fuel and must

then be closed again otherwise other ﬁring installations connected to the

chimney may be endangered.

Q The combustion chamber door is to be kept closed when the stove is not

in operation.

Q Fouling of the chimney i.e. deposits of highly inﬂammable materials such as

soot and tar and subsequently ﬁre in the chimney may occur if wet fuel is

used and operation is damped too much.

Q If this occurs, close the fresh air support (slider, regulator, ﬂaps - depending

on model)! Phone the ﬁre brigade and get yourself and other residents out

of harm’s way.

Note

on ROOM-AIR DEPENDENT and ROOM-AIR INDEPENDENT OPERATION:

Your stove has been tested as a room-air dependent stove according

to EN13240 and takes all the combustion air via the air intake from the

installation room.

In combination with room-air installations (e.g. controlled ventilation

and venting systems (extractors etc.) it must be ensured that the stove

and the room air system are monitored and safeguarded mutually (e.g.

via a differential pressure controller etc.). The combustion air infeed of

approx. 20 m3/h must be ensured.

Please observe the respective local regulations and rules in consultation with

your master chimney sweep. For changes after the printing of this manual, we

can not assume any liability. We reserve the right to change without notice.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rika Look Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Rika Look

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info