Bedienungsanleitung Rika Nex (Seite 12 von 16) (Englisch)

744633

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

6. MANUAL OPERATION

Note

For the operation of Rikatronic4 please see the enclosed manual

(Only for stoves with Rikatronic4)

Combustion air regulation

The performance of your stove also depends on the chimney

draught; therefore the control knob for combustion air regulation

must be used according to your own experience.

The primary air intake is absolutely necessary for heating up. The

“heating-up position“ may only be used for heating up.

Note

The air control seals to 100%. Complete closing of the air regulator

(zero setting of control knob) during operation poses a hazard of

deﬂagration and is strictly prohibited.

If the stove is not in use, warm air can release through the chimney.

The zero position of the control knob can prevent this.

Depending on model:

To prevent air intake completely, the control handle behind the air

control knob must be pulled to the front, only then the zero position

can be set and the air regulator thus be closed.

RIKA firelighter

Always ignite the RIKA ﬁrelighter on the red tip. One block consists

out of 8 ribs which can be divided to the desired size. The amount

of RIKA ﬁrelighters also depends on the size and humidity of your

ﬁrewood. Ideally, one rib is enough to light up the ﬁre.

Tip

You can order the RIKA ﬁrelighter with the number E15834 at your

RIKA dealer.

Correct heating up

1. Press the control knob completely into “heating-up position” –

primary and secondary air intakes are opened completely in the

heating-up position. Open the combustion chamber door and

sweep the ashes into the ashtray.

Place left and right two small pieces of chipboard lengthways in the

bottom of the combustion chamber.

Place two logs crossways on top of this chipboard.

2. Now place further pieces of chipboard in crosswise layers on top

of the logs and place 2-4 ribs of the RIKA-ﬁrelighter on the left on top

of the chipboard. Some uncoated paper can be placed underneath

the chipboard in case there is no ﬁrelighter available.

3. Now light the ﬁrelighter (or the uncoated paper) and close

the combustion chamber door. “Correct heating up” primarily

counteracts excessive smoke during heating up.

Set the control knob for combustion air regulation to middle position

some minutes later. The primary air intake is now closed and the

secondary air intake is completely open. The control can be set to

ideal position another few minutes later (depending on draught and

fuel quality / amount).

After the ﬁrst burn-off, again add two logs (see AMOUNT OF FUEL).

Set the control to “heating-up position” again until the wood is well

lit. Further regulation is effected as described in Item 3.

Please proceed in the same way for every further addition of wood.

Note

Sometimes a lot of smoke develops when wood is placed on a

low ﬁrebed or when there is too less fresh air for combustion. An

explosive gas/air mixture may arise and cause an eventual heavy

deﬂagration. For safety reasons it is recommended to leave the

combustion chamber door closed and press the control knob at

the rear wall down completely into “heating-up position”. If the

log wood is not igniting, start a new heating-up procedure after it

stopped smoking.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rika Nex Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Rika Nex

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info