745568
19
Zoom out
Zoom in
Vorherige Seite
1/20
Nächste Seite
Errors and warnings for button display
The LED display of the wireless receiver in the stove displays various errors.
If the LED display on the receiver is flashing in alternating green and red, there are two
transmitters with the same DIP switch settings within receiving range. Select another matching
switch setting for the sensor and receiver. The LED display will switch to normal mode and
show a continuous green.
If the LED display of the wireless receiver is flashing continuously green in a new installation,
this means it cannot connect to the wireless room sensor. Check the battery in the wireless
room sensor, and increase the transmitter power as described in the section on INSTALLATION.
Note
If the stove always heats to 25 °C, check DIP switch 4 of the wireless receiver.
For controlled heating, switch 4 must be in the OFF position.
Warnings in the display:
If the connection to the room sensor is interrupted, after approx. 10 minutes a warning is shown
on the display in moving text: ROOM SENSOR SIGNAL LOST. The stove switches to standby.
When the connection with the room sensor is restored, the warning automatically disappears
and the mode previously set continues.
While the ROOM SENSOR SIGNAL LOST” warning is displayed, the room sensor can be
switched off by pressing the I/O button. The stove switches to “HEAT” mode, and the further
procedure for operation in manual mode is described in your stove manual.
Action to be taken when errors are displayed:
Q Check the plug connection between the cable and the circuit board.
For the wireless room sensor, additionally:
Q Check the battery voltage of your wireless room sensor. (The LED on the wireless receiver
in the stove is lit red.)
Q Check for factors interfering with the wireless signal. Increase the transmitter power by
setting DIP switch 4 in the wireless room sensor to ON - see Installation.
|19
EN
18
19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Rika Room Temperature Sensor wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info