Bedienungsanleitung Rika Sumo (Seite 16 von 24) (Englisch)

744652

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

9. CLEANING

Depending on pellet consumption, a message prompting cleaning of the stove

appears on the display in regular intervals. This message can be acknowledged

on the Touch Display, while continuing operation. Perform a cleaning cycle at

the next opportunity.

Subsequently, reset the counter in the SETTINGS menu / RESETS submenu, as

per operating instructions of TOUCH DISPLAY.

Tip

The message will only stop reappearing once you have reset the feed volume

in the SETTINGS / Resets menu.

Note

Your stove must be switched off and cooled before any maintenance work is

performed. Only work on the unit when the mains plug has been disconnected.

Cleaning the convection air openings

Vacuum clean any dust deposits from the convection air openings at regular

intervals.

The stove should be cleaned thoroughly prior to the start of the heating season

to prevent excess odour.

Note

To prevent your stove from overheating of the internal components, do never

cover the convection ﬁns!

Combustion air - intake

If necessary, please also clean the air intake with a hoover.

Note

Only when the stove is cold! You could vacuum out embers – FIRE RISK!

Cleaning the pellet container

Do not reﬁll the completely empty container immediately; remove the residues

(dust, chippings etc.) from the empty container. The unit must be disconnected

from the mains!

Cleaning the flue pipes

(annually)

Remove the ﬂue pipes. Inspect and clean the chimney connection. Brush off any

soot and dust deposits in the ﬁre and in the ﬂue pipes and vacuum.

Note

Accumulated ﬂy ash in the ﬂue gas channels may impair the performance of

the stove and pose a safety risk.

Bearings

(annually)

All built-in bearings (pellet screw, turning grid) should be checked. Clean or

replace bearings depending on condition.

Checking door seal

(annually)

The condition of the seals at doors and glass should be checked at least once

a year. Repair or replace seals depending on condition.

Note

Only intact seals ensure your stove works perfectly!

Cleaning the flue gas channels and flue gas

collecting duct

The ﬂues are situated under and behind the combustion chamber.

Note

Only work on the unit when the mains plug has been disconnected and the

stove has cooled completely.

Note

During assembly / dismantling do not allow objects (screws etc.) to fall into

the pellet container – they can block the screw conveyor and damage the

stove.

Note

During any conversion work, take particular care of your ﬁngers and any

panels and stove attachments. Select soft bases to prevent scratches to your

living space furniture and stove panels.

Open the pellet container lid.

Open the decorative glass door. Remove the convection ﬁns by lifting them

straight up.

Loosen the wing nut on the lid of the cleaning opening, tilting the eyescrew

forwards. Open the lid. When cleaning the stove, be sure to either keep the

cleaning lid open or to laterally pull it out from its hinges to remove it.

Note

Please mind your ﬁngers! They could be injured by the lid falling down.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rika Sumo Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Rika Sumo

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info