• SPEED OFS: The Speed function is used to offset the aileron, elevator, and flap servos for minimum drag in cruise
and high-speed flight. Normally the ailerons and flaps are raised about 3-5°. (Some airfoils, notably the RG-15,
have higher drag with reflex, so this function should not be used.)
Adjustability:
• This function is only activated by flipping SWITCH G to the forward position. If you wish to have the three-
position SWITCH above the left-hand stick (position E), you should purchase a 9CH transmitter.
• Separate adjustments for each aileron and flap servo (two flap settings for GLID2FLP) and for elevator.
• Range for each adjustment is –100 to +100.
• Optional assignable dial to adjust all 4 wing servos in unison, 1% at a time across all 4 servos in flight.
GOAL of EXAMPLE: STEPS: INPUTS:
72
Set up a SPEED OFS to gain maximum
possible lift on launch.
Each Aileron: 5%.
Each Flap: 3%.
Elevator: -1% to compensate.
Note: switch and position are not
assignable. Must be the upper 3-
position S
WITCH
(G on 9CA, E on 9CH.)
Where next?
Open SPEED OFS function.
Activate the function.
Set the rates. (Ex: AIL1 and 2, 5%,
FLAP1 and 2, 3%, ELEV –1%.)
Optional: set up a dial to adjust travel
of all 4 wing servos in flight.
Close the function.
for 1 second.
(If BASIC menu , again.)
to 2nd page. to SPEED OFS.
Flip switch G away from you.
to OFF.
to AIL1
..
to +5%. to AIL2.
to +5%. to ELEV.
Repeat for ELEV, FLP1 and 2, AIL2.
to desired knob.
START OFS mixing. See p. 71.
BUTTERFLY. See p. 55.
Create a programmable mix to meet your model’s setups: see p. 59.
View additional model setups on the internet: www.futaba-rc.com\faq\faq-9c.html.
