●Selectthefunction name
and return to the Model
menu by touching the
RTN button.
<SensorTouch™>
CONDITION
Flight condition's switch assignment, copy, priority change and
condition delay can be set. [except airplane type]
This function, in the Model menu, can be used
to switch the settings of up to 5 ight conditions.
Please note this is not applicable to airplane type
selections.
Note: To prevent accidental activation of any
unused ight conditions during ight, set the
switch setting of those unused conditions to
null [--].
● A Condition Delay function can be set.
Unnecessary fuselage motion which may be
generated when there are sudden changes
in the servo positions and when there are
variations in the operating time between
channels during condition switching. The
delay can be set for each channel to ensure
maximum performance from your aircraft.
Whensettingthedelayfunctionforaspecic
ightcondition,therelatedfunctionchanges
after a delay corresponding to the set
amount.
● If mul t ip le co n di ti o ns we r e set , th e ir
operational priority may be customized as
desired.
(Currently selected condition name)
● Select [CONDITION] at the Model menu and
access the setup screen shown below by touching
the RTN button.
Select the copy destination condition by
scrolling the touch sensor. Then, touch the
RTN button.
*The current condition can not be selected for the copy
destination condition.
3. Move the cursor to the [COPY] item and
touch the RTN butt on. A conf irmat ion
message appears.
*The display blinks.
3. Touch the RTN button for one second and
the copying is completed. (Touch the S1
button to stop copying.)
Priority change
1. Move the cursor to the priority up-arrow or
down-arrow you want to change and touch
the RTN button.
The priority of the corresponding condition is
changed. (The last condition becomes the
highest priority.)
*The normal condition cannot be shifted. The priority is the
lowest.
Condition switch selection/deletion
1. Move the cursor to the switch item of the
condition you want to select/delete and
access the switch setup screen by touching
the RTN button and select the switch and ON
direction.
*For a detailed description of the setting method, see [Switch
Setting Method] at the back of this manual.
Condition copy
(Setup screen page 3)
1. Move the cursor to the [SOURCE] item and
touch the RTN button to switch to the data
input mode.
Select the copy source condition by scrolling
the touch sensor. Then, touch the RTN button.
2. Move the cursor to the [DESTIN.] item and
touch the RTN button.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
(Condition name) (Condition switch)
