●Selectthefunction name
and return to the Model
menu by touching the
RTN button.
<SensorTouch™>
MOTOR
[Corresponding model type]: Airplane/glider, general
This function lets you set the speed when the
motor of an F5B or other EP glider is started via
a switch. The operation speed can be set for two
ranges, slow speed flight and high speed flight
(Speed 1/Speed 2). This function can also be
operated as a safety function by programming it to
a switch.
● TheInsideand Out sideoperatingspeeds can
be adjusted independently in 2 ranges (Speed 1/
Speed 2).
●Theboundarybetweenthe2ranges can be set.
(From Speed 1 to Speed 2)
●The operationalspeedcan onlybe activatedat
the initial operation. However, operation can be
repeated by setting the switch to OFF before the
operationisnished.Whenyouwanttoresetone
time operation, set the ACT/INH item to [INH] and
then reset it to [ON].
●The motorchanneliscontrolledbySW-G.(Glider:
Initial setting) When changing the switch or stick
whichcontrolsthemotor,rstchangeFunctionof
the Linkage menu.
Note: Initial setting does not assign a motor
channel according to the model type. Prior to
assigning the motor channel, nd an unused
channel. Then, use the Function menu of the
Linkage menu.
Set [Control] to the switch you want to use
and [Trim] to [--].
Note: When using this function, always check
the initial operation with the propeller
removed.
●Select [MOTOR] at the Modelmenu
and access the setup screen shown
below by touching the RTN button.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
Setting method
● Activate the function
When using this function, move the cursor to
the [ACT/INH] item and touch the RTN button
to switch to the data input mode. Select the
[ACT] by scrolling the touch sensor and touch
the RTN button.
When selecting the ON/OFF switch, move the
cursor to the switch item and touch the RTN
button to access the selection screen. Select
the switch and set its ON direction. (Always
ON at "--" setting)
*For a description of the switch selection method, see the
description at the back of this manual.
● Motor off position setting
Move the cursor to the [MOTOR OFF] item
and touch the RTN button for one second
when the motor function switch (SG, etc.) is
in the motor OFF position you want to set. The
direction of the motor switch is memorized.
The screen graph display OFF direction also
changes.
Note:
● First decide the motor OFF direction, and then
set the speed. When you want to reset the
motor OFF direction, also reset the speed.
● We recommend that Motor OFF be set in
combination with F/S.
● Set the basic operation direction with the
Reverse function to match the ESC used.
● Always set the Motor OFF position.
