625559
30
Zoom out
Zoom in
Vorherige Seite
1/46
Nächste Seite
NX SERIES V0913 29
English
Fig.14
Use of the cross-cut fence (g. 15)
The measuring tape of the cross-cut fence is factory set. To make sure the measurements correspond
to the index, do the test where you place the 2 ip-stops on a certain distance and check if the
obtained distances are the same as the distances of the index.
Lock the ipper at a dened length and cut off a sample.
Now take the exact measurements of the sample.
To calibrate the index, remove the 2 handles of the fence on the table, without removing the fence from
the outrigger table. Inside the 2 locating pins of the fence you will nd a socket cap screw.
Loosen the two socket caps, which enable you to move the fence to equalize the measurements with
the index.
Tighten the two socket cap screws again and place the 2 locking handles. To calibrate the index on the
telescopic part, loosen the 2 socket caps holding the short part of the fence on the square telescopic
tube. Now repeat above in order to calibrate the scale on the telescopic part of the fence.
Tighten the two socket cap screws again.
Fig.15
1
30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Robland NXTZ wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Robland NXTZ

Robland NXTZ Bedienungsanleitung - Deutsch - 100 seiten

Robland NXTZ Bedienungsanleitung - Holländisch - 100 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info